Steps on non-rail vehicles shall comply with T405.
Search Results "Bus Boarding Area"
-
T203.1 General
-
CHAPTER 2: SCOPING REQUIREMENTS
[See subsections ...]
-
12185(a) Purposes
(a) Purposes The Office of Technology Assessment shall undertake a study to determine
-
§ 38.171(c)
Architectural and Transportation Barriers Compliance Board (Access Board)....
-
Introduction
Introduction The Access Board is an independent federal agency established by section 502 of the Rehabilitation Act (29 U.S.C. 792).1 The Access Board is responsible for developing accessibility...
-
A. Door Width
Achieving a 30 inch wide front door on an over-the-road bus is considered not feasible if doing so would necessitate reduction of the bus approach angle, relocating the front axle rearward...
-
9. Outdoor Developed Areas
The Board has issued requirements that are now part of the Architectural Barriers Act (ABA) Accessibility Standards and apply to national parks and other outdoor areas developed by the federal...
-
9. Outdoor Developed Areas
The Board has issued requirements that are now part of the Architectural Barriers Act (ABA) Accessibility Standards and apply to national parks and other outdoor areas developed by the federal...
-
9. Outdoor Developed Areas
The Board has issued requirements that are now part of the Architectural Barriers Act (ABA) Accessibility Standards and apply to national parks and other outdoor areas developed by the federal...
-
9. Outdoor Developed Areas
The Board has issued requirements that are now part of the Architectural Barriers Act (ABA) Accessibility Standards and apply to national parks and other outdoor areas developed by the federal...
-
R308.1.2.2 Slope
Boarding platforms shall not exceed a slope of 2 percent in any direction....
-
§382.91 What assistance must carriers provide to passengers with a disability in moving within the terminal?
[See subsections ...]
-
11B-234.4.1 Load and unload areas
Where load and unload areas serving existing amusement rides are newly designed and constructed, the load and unload areas shall comply with Section 11B-1002.3....
-
11B-234.4.1 Load and unload areas
Where load and unload areas serving existing amusement rides are newly designed and constructed, the load and unload areas shall comply with Section 11B-1002.3....
-
11B-206.2.9.1 Load and unload areas
Load and unload areas shall be on an accessible route....
-
11B-206.2.9.1 Load and unload areas
Load and unload areas shall be on an accessible route....
-
IV.B.1.
Where destination or route information is displayed on the exterior of a vehicle, each vehicle shall have illuminated signs on the front and boarding side of the vehicle....
-
Work Areas
Work Areas Storage facilities used by employees for purposes other than job-related tasks, such as break room cabinets and shower room lockers, are required to be accessible....
-
Play Area
Play Area - A portion of a site containing play components designed and constructed for children....
-
11B-1002.3 Load and unload areas
A turning space complying with Sections 11B-304.2 and 11B-304.3 shall be provided in load and unload areas....
-
11B-1002.3 Load and unload areas
A turning space complying with Sections 11B-304.2 and 11B-304.3 shall be provided in load and unload areas....
-
12186(c) Consistency with ATBCB guidelines
issued under subsections (a) and (b) of this section shall be consistent with the minimum guidelines and requirements issued by the Architectural and Transportation Barriers Compliance Board...
-
§ 38.23(c)(6) Attachment
When in use for boarding or alighting, the ramp shall be firmly attached to the vehicle so that it is not subject to displacement when loading or unloading a heavy power mobility aid and...
-
§ 38.23(c)(5) Slope
(5) Slope. Ramps shall have the least slope practicable and shall not exceed 1:4 when deployed to ground level. If the height of the vehicle floor from which the ramp is deployed is...