The definitions of those terms, as well as terms defined in ADA, are located in Section 202....
Search Results "Securement Location"
Filters
Commonly Searched Documents
-
11B-106.5 Defined terms
-
Americans with Disabilities Act: Assistance at Self-Serve Gas Stations
At locations with only self-serve pumps, they might be unable to purchase gas at all....
-
Wheelchair Spaces in Tiered Boxes
Often, steps are located on the route to these boxes. The proposed rule was not clear on how the scoping and dispersion requirements would apply in these types of facilities....
-
209 Passenger Loading Zones and Bus Stops
Revisions have been made to: clarify the basic scoping provision (209.2.1) integrate requirements for bus loading zones and bus stops previously located in a separate chapter covering...
-
1002.6 Transfer Devices for Use with Amusement Rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
Ground-Level Play Components
Grouping all ground-level play components accessed by children with disabilities in one location does not constitute integration....
-
9. Outdoor Developed Areas
The new requirements are located in sections F201.4, F216.3, F244 to F248, and 1011 to 1019 of the ABA Standards....
-
407.4.1 Car Dimensions
Table 407.4.1 Elevator Car Dimensions Minimum Dimensions Door Location Door Clear Width Inside Car, Side to Side...
-
4.4.3 Implications of Mammography Equipment Components
Figure 4.3.3(a) illustrates the terminology and the location on a mammography device that the Committee used to describe mammography components....
-
QUESTION: HOW IS IT DETERMINED WHAT KIND OF AUXILIARY AID OR SERVICE A PVO WILL PROVIDE TO A PASSENGER WITH A DISABILITY?
*Because locating a sign language interpreter to provide services to a passenger on some types of voyages can be time-consuming and difficult for PVOs, it is particularly important for passengers...
-
F244.2 Camping Units with Mobility Features
Entities should provide information on the location of camping units with mobility features on websites, in brochures, and at bulletin boards or information kiosks at the camping facility...
-
Accessible Routes on the Playing Surface
Designers should consider locating this opening in an area where the ball is not likely to roll....
-
Alternative Golf Car Passage
The golf car passage could be located on areas such as fairways, greens, and teeing surfaces....
-
Technical Memorandum TM 2013-14 Dining Surfaces
Therefore, accessible dining surfaces shall be 30” minimum in length based on 305.5 or 36” minimum if the clear floor space is located in an alcove based on TAS 305.7.1. ...
-
Technical Memorandum TM 2013-23 Storage (Not in Kitchens or Kitchenettes)
compliance with TAS 225.2, the Department shall consider base and wall cabinets to be the same type of storage if designed the same (i.e. both have doors), used for the same purpose, and located...
-
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations The Committee recommends standing supports located on both sides of platforms,...
-
1002.6 Transfer Devices for Use with Amusement Rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
5.3.2.2 Transfer Sides Recommendation for Imaging Equipment
Imaging manufacturers noted that many X-ray system tables and all DXA tables with today’s technology have part of the imaging equipment support located on one of the long sides and all patient...
-
COSTS TO LOWER MINIMUM TABLE HEIGHT
The mechanical system necessary to raise the table are located in the base of the table, beneath the seating surface....
-
Water Hydrants and Water Spouts [1011.2, 1011.3, and 1011.6]
The clear ground space must be located so that the water spout is between 11 and 12 inches from the rear center of the long side of the space....
-
M301.2.3 Transfer Surface Transfer Sides
However, many X-Ray system tables and all DXA tables will have part of the imaging equipment support located on one of the long sides and only all transfers are made from the other....
-
Continuous Width (R302.3) (Section-by-Section Analysis)
The proposed guidelines specify a minimum width of 1.2 meters (4 feet) in order to allow for street furniture and other objects that may be located on sidewalks....
-
Scenario 8 – Accessibility
School districts are required to have procedures in place to ensure that parents, students, and other interested persons can obtain information about the location of services, activities...
-
Initial Measures and Transfer Setup
This location was chosen to account for any hammocking, wear or compression of the seat upholstery and/or cushion. ...