Where shooting facilities with firing positions are designed and constructed at a site, at least 5 percent, but no fewer than one, of each type of firing position shall comply with 1010....
Search Results "Seat Designation"
-
243.1 General
-
238.2.3 Weather Shelters
Where provided, weather shelters shall be designed and constructed so that a golf car can enter and exit the weather shelter and shall comply with 1006.4....
-
11B-209.4 Valet parking
Some vehicles may be adapted with hand controls or lack a driver’s seat, and may not be operable by a valet parking attendant....
-
Technical Memorandum TM 2013-11 Benches
Steam Rooms TAS 612.2 Dressing, Fitting, and Locker Rooms TAS 803.4 Holding Cells and Housing Cells TAS 807.2.2 Fixed or built-in benches and other types of fixed seating...
-
Access to Performing Areas [4.33.5]
While handrails are not required on ramps adjacent to assembly seating, locating aisles (including those that are stepped) along walls will permit handrails on one side for the benefit of...
-
Wheelchair Spaces
Wheelchair spaces should not overlap required exit widths or circulation paths and should provide for shoulder-to-shoulder alignment with occupants of adjacent seats (an important consideration...
-
Printable Room Layouts
If your meeting will have more than 10% of attendees using mobility devices or service animals, increase the number of accessible seating locations and aisle widths proportionally....
-
Error/Omission: When a transfer shower is used, it is often larger than the required 36" x 36" size.
Users may slide off the seat and fall onto the floor of the shower while reaching for the shower controls and hand-held showerhead. Requirement: 4.21.2 Size and Clearances....
-
1009.3.3 Area of Refuge
Areas of refuge are not required for smoke-protected or open-air assembly seating areas complying with Sections 1029.6.2 and 1029.6.3....
-
Sections 5 Through 9 (Preamble, Section-by-Section Analysis)
., Check-out Aisles, provides that, in new construction, a certain number of each design of check-out aisle, as listed in a chart based on the total number of checkout aisles of each design...
-
IV. Public Comments and Commenters
, design consultants, manufacturers of home building products, and rental managers....
-
Workshops
Access Board prior to this project, we held two international workshops that focused on current issues of applying the anthropometric data of individuals with disability to design....
-
Sections 5 Through 9 (Section-By-Section Analysis and Response to Comments)
., Check-out Aisles, provides that, in new construction, a certain number of each design of check-out aisle, as listed in a chart based on the total number of check-out aisles of each design...
-
Issues Related to the Interactive Process and Return to Work
The employer asks if the employee could do seated work during the break; the doctor says yes....
-
B.2.ii. - How should an agency proceed in identifying "applicable" technical provisions in Subparts B, C, and D of the Access Board’s standards to ensure acquired products provide comparable access?
For example, if an agency were to enter into a seat management contract for desktop computing resources, the hardware and software to be provided by the contractor would be required to meet...
-
Storing Assistive Devices in the Aircraft Cabin
[Sec. 382.41(b)] You must permit passengers to stow their canes and other assistive devices in the cabin and close to their seats, consistent with FAA safety regulations concerning carry-on...
-
11B-1008.3 Transfer systems
Designers should minimize the distance between the points where a child transfers from a wheelchair or mobility device and where the elevated play components are located....
-
11B-1008.3 Transfer systems
Designers should minimize the distance between the points where a child transfers from a wheelchair or mobility device and where the elevated play components are located....
- VocRehab Vermont - Division of Vocational Rehabilitation
-
F234.4.2 Minimum Number
structural or operational characteristics of an amusement ride are altered to the extent that the amusement ride's performance differs from that specified by the manufacturer or the original design...
-
‘‘Complete complaint.’’
‘‘Complete complaint’’ is defined to include all the information necessary to enable the Federal agency designated under subpart G as responsible for investigation of a complaint to initiate...
-
§ 1194.21(a)
(a) When software is designed to run on a system that has a keyboard, product functions shall be executable from a keyboard where the function itself or the result of performing a function...
-
§27.71(k)
Shared-use automated airport kiosks provided in accordance with paragraph (j) of this section must conform to the following technical accessibility standards with respect to their physical design...
-
§ 27.71(k)
Shared-use automated airport kiosks provided in accordance with paragraph (j) of this section must conform to the following technical accessibility standards with respect to their physical design...