Test Method for Determining Floor Tolerances Using Waviness, Wheel Path and Levelness Criteria (Metric) ASTM F 802-83(2003) Standard Guide for Selection of Certain Walkway Surfaces...
Search Results "Parking Surface"
Filters
Commonly Searched Documents
-
Industry Standards
-
4. Organization of Technical Criteria
For example, X-ray equipment that is designed for use in a standing position for certain procedures would have to meet the technical criteria for slip resistant standing surface and standing...
-
Introduction
Environmental Access Golf Course Superintendents Association of America Hawaii Disability and Communication Access Board International Association of Amusement Parks...
-
Introduction
Environmental Access Golf Course Superintendents Association of America Hawaii Disability and Communication Access Board International Association of Amusement Parks...
-
Introduction
Environmental Access Golf Course Superintendents Association of America Hawaii Disability and Communication Access Board International Association of Amusement Parks...
-
Introduction
Environmental Access Golf Course Superintendents Association of America Hawaii Disability and Communication Access Board International Association of Amusement Parks...
-
Introduction
Environmental Access Golf Course Superintendents Association of America Hawaii Disability and Communication Access Board International Association of Amusement Parks...
-
Introduction
Environmental Access Golf Course Superintendents Association of America Hawaii Disability and Communication Access Board International Association of Amusement Parks...
-
218 and 810 Transportation Facilities
Detectable warnings provide a distinctively textured surface of truncated domes....
-
QUESTION: WHAT CONSTITUTES AN ALTERATION TO A PLATFORM FOR PURPOSES OF TRIGGERING THE APPLICATION OF SECTION 37.42 REQUIREMENTS?
For example, if the platform height relative to the top of rail is raised, if the old surface is removed and/or a new surface put down, or if there is a reconstruction of or structural change...
-
1016.5 Obstacles
The vertical alignment of joints in concrete, asphalt, or board surfaces on outdoor recreation access routes can be obstacles....
-
Purpose of the project
For instance, when this project began, tolerances for the measurement of the slope, flatness, and smoothness of exterior walking and rolling surfaces in concrete, asphalt, unit masonry,...
-
Clearance Around Base (M301.4.2 and M302.4.2)
M302.4.2 would require the base of the equipment to provide a clearance 6 inches high minimum measured from the floor and 36 inches deep minimum measured from the edge of the examination surface...
-
§ 38.159(b)(13) Handrails
The handrail shall have a cross-sectional diameter between 11/4 inches (32 mm) and 11/2 inches (38 mm) or shall provide an equivalent grasping surface, and have eased edges with corner radii...
-
§ 38.29(b)
Handrails shall have a cross-sectional diameter between 11/4 inches and 11/2 inches or shall provide an equivalent grasping surface, and have eased edges with corner radii of not less than...
-
11B-704.5 TTY shelf
The telephone handset shall be capable of being placed flush on the surface of the shelf....
-
704.5 TTY Shelf
The telephone handset shall be capable of being placed flush on the surface of the shelf....
-
1131A.2 Changes greater than ½ inch
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
-
1013.1 General
Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
-
I. Introduction
The purpose of this Minority Report is to make a formal recommendation for a minimum transfer surface low height of 19 inches for diagnostic imaging medical equipment....
-
704.5 TTY Shelf
The telephone handset shall be capable of being placed flush on the surface of the shelf....
-
CONCLUSION
Access Board adopt the subcommittee's original recommendations to require an adjustable range of 19 to 25 inches for the transfer surface of examination tables and chairs during patient...
-
4.31.9(2)
The telephone handset shall be capable of being placed flush on the surface of the shelf....
-
R409.10 Handrail Extensions
Handrail gripping surfaces shall extend beyond and in the same direction of ramp runs and stair flights in accordance with R409.10....