Recommended mounting heights for grab bars are 33" - 36" centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates....
Search Results "Floor Identification"
Commonly Searched Documents
- AJW Architectural Products UG30-Railing UG30X-Y108 108" Concealed Set Screw Flange, 1.5" Diameter, Peened Grip - Configuration Y
- AJW Architectural Products UG3-A Series UG3-A12 12" Concealed Snap Flange, 1.5" Diameter Grab Bar - Configuration A
- AJW Architectural Products UG130-A Series UG130-A12 12" Exposed Flange, 1.5" Diameter Grab Bar - Configuration A
- AJW Architectural Products UG20-Railing UG20X-Y108 108" Concealed Set Screw Flange, 1.25" Diameter, Peened Grip - Configuration Y
- AJW Architectural Products UG2-A Series UG2-A12 12" Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration A
- AJW Architectural Products UG120-A Series UG120-A12 12" Exposed Flange, 1.25" Diameter Grab Bar - Configuration A
-
Section 35.151(e) Social service center establishments
In the NPRM, the Department expressed concern that the residential facilities standards do not include a requirement for clear floor space next to beds similar to the requirement in the...
-
Section 35.151(e) Social service center establishments (Section-by-Section Analysis)
In the NPRM, the Department expressed concern that the residential facilities standards do not include a requirement for clear floor space next to beds similar to the requirement in the...
-
A. DEFINITIONS AND BACKGROUND
In order to be deemed accessible, a bed must (i) lower to a point no greater than 17-19 inches from the floor, and (ii) be capable of being locked or otherwise fixed into position so as...
-
19 Inch Low Height
The height of water closet seats shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the floor, measured to the top of the seat....
-
Meeting ANSI Standard S12.60 Requirements
Reducing Noise Traveling Through the Plenum – Walls do not always extend all the way up to the finished deck of the floor above. Instead they often stop at the suspended ceiling line....
-
4.3.8 Operating forces
Adequate clear floor space should be provided to access controls and switches from either the left or the right (see previous description of ‘Clear Floor Space for Reaching’)....
-
III-7.3110 Work areas
. , an actual floor level) used, for example, as an employee lounge area?...
-
DSA IR 16-12: GRAB BAR DESIGN AND CONNECTIONS: 2019 CBC
DSA will not review the design of the bar itself. 2.5 Grab bars shall not be installed on partitions without supports extending to the floor (i.e., partitions hung from the upper floor...
-
1003.2.1 Boat Slips
Where handrail extensions are provided on gangways or transition plates, the handrail extensions shall not be required to be parallel with the ground or floor surface. 7....
-
11B-703.8.4 Character height
TABLE 11B-703.8.4 LOW RESOLUTION VMS CHARACTER HEIGHT HEIGHT ABOVE FLOOR TO BASELINE OF CHARACTER HORIZONTAL VIEWING DISTANCE MINIMUM CHARACTER...
-
Exam Tables and Chairs
An accessible exam table or chair should have at least have the following: ability to lower to the height of the wheelchair seat, 17‒19 inches from the floor; and elements to stabilize...
-
1003.2.1 Boat Slips
Where handrail extensions are provided on gangways or transition plates, the handrail extensions shall not be required to be parallel with the ground or floor surface. 7....
-
1003.2.1 Boat Slips
Where handrail extensions are provided on gangways or transition plates, the handrail extensions shall not be required to be parallel with the ground or floor surface. 7....
-
5.8.2.1 Height of Breast Platform at Time of Measurement
Breast Platform at Time of Measurement Recommendation The Committee recommends measuring all knee and toe clearances when the top of the breast platform is set at 34 inches above the floor...
-
2.7 Existing ADA and Rehabilitation Act Requirements for Accessible Medical Care
The guidance document includes information on accessible examination rooms and the clear floor space needed adjacent to medical equipment for individuals who use mobility devices to approach...
-
DSA IR 11B-6 MECHANICAL ONLY PROJECTS EXEMPT FROM ACCESSIBILITY REVIEW (with revisions issued through Jan. 2011)
It should be noted that compliance with the building code is still required (i.e. the height of thermostats shall be installed 48” above the finish floor to the operating handle)....
-
Trailhead Signs
Locate trailhead information signs centered at the back of a 30- by 48-inch (760- by 1,220-millimeter) -minimum clear floor or ground space....
-
Appendix Two: Design Information and Accommodation Models
Study findings on Armrest height, calculated as the mean height of the four corner points of the arm rest on the right side measured from the floor....