services of personnel and the use of ground wheelchairs, accessible motorized carts, boarding wheelchairs, and/or on-board wheelchairs where provided in accordance with this part, and ramps...
Search Results "Ramp Surface"
-
§382.95(a)
-
Problem Two
Solution: Use traffic cones to mark and block off the access aisle and curb ramp area. ...
-
Problem Four
Cones mark the access aisle and a temporary curb ramp with edge protection connects to an accessible route to the polling place....
-
§ 38.159(b)(9) Platform deflection
The lift platform (not including the entrance ramp) shall not deflect more than 3 degrees (exclusive of vehicle roll or pitch) in any direction between its unloaded position and its position...
-
§ 38.93(d)(3) Exception
horizontal gap or vertical alignment specified in paragraph (d)(1) or (d)(2) of this section, car, platform or portable lifts complying with §38.95(b) of this part, or car or platform ramps...
-
CURB CUT
An interruption of a curb at a pedestrian way, which separates surfaces that are substantially at the same elevation....
-
11B-705.1.1 General
Detectable warnings shall consist of a surface of truncated domes and shall comply with Section 11B-705....
-
GRADE BREAK
[DSA-AC] The line where two surface planes with different slopes meet....
-
903.7 Wet Locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....
-
11B-903.7 Wet locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....
-
TRANSITION PLATE
[DSA-AC] A sloping pedestrian walking surface located at the end(s) of a gangway....
-
4.1.2(3)
(3) All objects that protrude from surfaces or posts into circulation paths shall comply with 4.4....
-
Minimum Trail Width
The width of the trail tread and the adjacent usable surface at the narrowest point on a trail. ...
-
4.1.1(3)
(3) All objects that protrude from surfaces or posts into circulation paths shall comply with 4.4....
-
4.32.1 MINIMUM NUMBER
Fixed or built-in seating, tables, or work surfaces required to be accessible by 4.1 shall comply with 4.32....
-
Tent Platform
An outdoor space designed and constructed for setting-up and securing tents that is elevated above the ground surface....
-
11B-903.7 Wet locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....
-
11B-705.1.1 General
Detectable warnings shall consist of a surface of truncated domes and shall comply with Section 11B-705....
-
11B-903.7 Wet locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....
-
903.7 Wet Locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....
-
705.1 General
Detectable warnings shall consist of a surface of truncated domes and shall comply with 705....
-
Lift Compatibility (M301.4 and M302.4)
A patient lift may be the only means of providing access to certain equipment that cannot meet the technical criteria for transfer surface height (see M301.2.1 and M302.2.1) because of the...
-
Section 810.2.2
We note that there may be some instances in which it will be necessary to make operational adjustments where sufficient clearance is not available to permit the deployment of lifts or ramps...
-
11B-705.1.2.3 Islands or cut-through medians
cut-through less 2 inches (51 mm) maximum on each side, placed at the edges of the pedestrian island or cut-through median, and shall be separated by 24 inches (610 mm) minimum of walking surface...