The median buttock-popliteal length provides an upper bound for the depth of a seating surface....
Search Results "Standing Surface"
Commonly Searched Documents
-
3. Buttock-Popliteal Length
-
3.3 Data Sources
Early on, it became clear that some Committee members were unfamiliar with issues raised during transfers from a wheelchair or scooter onto a surface such as an examination table....
-
4.3.3 Imaging Equipment Used for Interventional and Biopsy Procedures with Sedated Patients
patients undergoing these procedures receive some form of sedation prior to transfer.CC When sedated, all patients – regardless of their physical abilities – are assisted onto the transfer surface...
-
Beach Access Routes
A beach access route is a continuous, unobstructed path that crosses the surface of the beach and provides pedestrians access to the water....
-
Front grab bar protocol
The preferred grab bar height was measured between the floor and the top of the grab bar surface. ...
-
Maintenance (Trail Terminology)
trails, clearing the trail of encroaching brush or grasses, and removing rock slides Maintaining trail tread, such as filling ruts, reshaping a trail bed, repairing a trail surface...
-
Edge Protection [4.8.7]
A rail mounted close enough to the ramp surface to prevent passage of a 4 inch diameter sphere can function like a curb in keeping front casters from getting stuck on vertical posts and...
-
Sales and Service Counters
This provides a lowered surface where goods and services and money can be exchanged. An alternative solution is to provide an auxiliary counter nearby....
-
11B-703.4.2 Location
When tactile signs are mounted inconsistently on surrounding wall surfaces, or mounted on the door itself, they are difficult to find and may create a safety hazard....
-
M305.2.4 Cross Section (Section-by-Section Analysis)
The Access Board sought input in MDE NPRM preamble question 21, on whether the gripping surfaces of current transfer supports on different types of equipment meet the cross sectional dimensions...
-
5.8.1.1 Clear Platform Size Recommendation
33.8 34 -- -- -- 34.5 The Wheeled Mobility Anthropometry Project recommends a minimum flat surface...
-
Trailhead Information Signs [F216.13 and 1017.10]
The new trail information signs must include the following information: Length of the trail or trail segment Type of trail surface Typical and minimum trail tread...
-
T402 Ramps and Bridgeplates
The technical requirements for ramps and bridgeplates in the 2016 Non-Rail Vehicle Guidelines include provisions on design load, installation and operation, emergency operation, surfaces...
-
Water Hydrants
Locate water spouts between 28 inches (710 millimeters) and 36 inches (915 millimeters) above the ground or floor surface on the edge of a clear space that is at least 72 inches (1,830 millimeters...
-
F - number system
The flatness number also gives an indication of the "bumpiness" of the surface. The F - number system develops two number ratings, the FF and the FL....
-
11B-703.4.2 Location
When tactile signs are mounted inconsistently on surrounding wall surfaces, or mounted on the door itself, they are difficult to find and may create a safety hazard....
-
11B-703.4.2 Location
When tactile signs are mounted inconsistently on surrounding wall surfaces, or mounted on the door itself, they are difficult to find and may create a safety hazard....
-
Viewing Areas
When the surface isn't paved or built with boards, allow grades up to 1:33 (3 percent) in any direction if needed for proper drainage....
- Bradley Chrome-Plated Die Cast Single Robe Hook 931
- American Specialties Circular Counter Top Waste Chute 1000
- American Specialties Single Robe Hook 0740-Z
- Bradley 3-Station Frequency Lavatory System FL-3H & FL-3L
- Stanley QRM 100 Series Grade 1 Extra Heavy Duty Exit Devices
- Door King Inc. 1803 Telephone Entry System