Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
Search Results "Surface Slope"
-
1002.6 Transfer Devices for Use with Amusement Rides
-
R210.3 Shared Use Paths
Objects shall not overhang or protrude into any portion of a shared use path at or below 2.4 m (8.0 ft) measured from the finish surface....
-
1002.6 Transfer Devices for Use with Amusement Rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
4. Wheelchair seat depth
The median seat depth across different wheeled mobility devices would provide a reference value for the depth of other common seating surfaces....
-
COSTS TO LOWER MINIMUM TABLE HEIGHT
The need to reach heights above 32 inches interferes with efforts to lower the transfer surface height....
-
Initial Measures and Transfer Setup
This approach is also widely promoted in rehabilitation research (A Clinical Application Guide to Standardized Wheelchair Seating Measurements of the Body and Seating Support Surfaces, See...
-
3. FIXTURES and HARDWARE
If self-closing valves are used, the faucet shall remain open for at least 10 seconds.”xxii Sinks Exposed Pipes and Surfaces: Hot water and drain pipes under lavatories...
-
Multiple Parking Facilities on a Site
., surface lot versus parking garage or deck); dedicated to, and separately serve, different facilities on a site; segmented and separated by guard rails, fencing, or barriers...
-
11B-1002.6 Transfer devices for use with amusement rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
11B-1002.6 Transfer devices for use with amusement rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
810 Transportation Facilities
The Board has explicitly specified that rail platforms shall slope no more than 1:48 in any direction, consistent with cross slope provisions for walking surfaces in section 403....
-
A. ACCESSIBLE SEATING
Wheelchair Spaces shall be thirty six (36) inches wide (or as otherwise required by Section 802), located on a level floor surface, and shall adjoin accessible routes. ...
-
AquaTrek2 ADA Step System
The AquaTrek2 ADA Pool Steps have a sloped inner rail set that provides additional support to the user as well as providing the facility easy removal. ...
-
Behavioral Safety Products #SF370 Ligature Resistant Sensor Faucet
Product Description: This infrared sensor faucet is sloped and rounded to prevent ligature....
-
Wooster Products Flexmaster Safety Tread
Inexpensive Easily replaceable Color coordinated surfaces available ADA approved Durable safety surface Glow-in-the-dark capability Longwearing, newly designed, heat treated...
-
Garaventa Evacu-Trac CD7 Evacuation Chair
As a standard measurement, on a stair slope of 35 degrees and with a passenger of 220 lbs. (100kg), the speed control mechanism shall limit the descent speed to a maximum of 3.6 ft/sec....
-
Appendix A: Pedestrians with Visual Impairments
the two surfaces....
-
11B-703.4.2 Location
When tactile signs are mounted inconsistently on surrounding wall surfaces, or mounted on the door itself, they are difficult to find and may create a safety hazard....
-
11B-703.4.2 Location
When tactile signs are mounted inconsistently on surrounding wall surfaces, or mounted on the door itself, they are difficult to find and may create a safety hazard....
-
Where must curb ramps be provided?
However, the ADA does not require installation of ramps or curb ramps in the absence of a pedestrian walkway with a prepared surface for pedestrian use....
-
11B-407.2.1.5 Signals
Call buttons shall be internally illuminated with a white light over the entire surface of the button. [2010 ADAS] 407.2.1.5 Signals. ...
-
505.10 Handrail Extensions
Handrail gripping surfaces shall extend beyond and in the same direction of stair flights and ramp runs in accordance with 505.10. EXCEPTIONS: 1....
-
11B-703.7.1 Finish and contrast
Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
