Interior hinged doors and gates: 5 pounds (22.2 N) maximum. 2. Sliding or folding doors: 5 pounds (22.2 N) maximum. 3. ...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
-
11B-404.2.9 Door and gate opening force
-
11B-404.2.9 Door and gate opening force
Interior hinged doors and gates: 5 pounds (22.2 N) maximum. 2. Sliding or folding doors: 5 pounds (22.2 N) maximum. 3....
-
11B-404.2.9 Door and gate opening force
The force for pushing or pulling open a door or gate other than fire doors shall be as follows: Interior hinged doors and gates: 5 pounds (22.2 N) maximum....
-
11B-706.1 General
The technical standards for assistive listening systems describe minimum performance levels for volume, interference, and distortion....
-
M305.3.1 Length (Section-by-Section Analysis)
The MDE Advisory Committee supported the proposed technical provisions, but recommended adding additional criteria for standing supports on raised platforms with wheelchair spaces....
-
36 CFR Part 1194 Electronic and Information Technology Accessibility Standards (Section 508 Standards) - Preamble
Section 508 requires the Access Board to publish standards setting forth a definition of electronic and information technology and the technical and functional performance criteria necessary...
-
11B-706.1 General
The technical standards for assistive listening systems describe minimum performance levels for volume, interference, and distortion....
-
II. Definitions of Standards and Guidelines Referenced in This Document
the ADA and the Architectural Barriers Act (ABA).1 2004 ADAAG means the requirements set forth in Appendices B and D to 36 CFR 1191 which are the ADA scoping chapters and the common technical...
-
Midmark 641 Barrier-Free® Power Procedures Chair
Narrow patient support surface, slim back section and tuck away side rails provide maximum patient accessibility and supports proper posture Powered seat, back, foot and tilt offer multi-positioning...
-
Hadrian Inc. Gladiator Athletic Lockers
Maximum Ventilation Fully ventilated doors and sides with 0.5” x 1” (13 mm x 25 mm) oval perforations allow for maximum air circulation as well as visual access....
-
Key Differences Between Routes
The following descriptions and review of the technical requirements for each type of route provides a quick reference to aid with this process....
-
11B-1009.5.6 Size
Each transfer step shall have a tread clear depth of 14 inches (356 mm) minimum and 17 inches (432 mm) maximum and shall have a tread clear width of 24 inches (610 mm) minimum....
-
604.8.3 Coat Hooks and Shelves
Shelves shall be located 40 inches (1015 mm) minimum and 48 inches (1220 mm) maximum above the finish floor. [ECTCR UFAS 4.25.3, Fig. 38, 4.23.9, 4.34.5.3(3)]...
-
1009.4.3 Wall Depth and Length
The depth of the transfer wall shall be 12 inches (305 mm) minimum and 16 inches (405 mm) maximum....
-
803.5 Coat Hooks and Shelves
Shelves shall be 40 inches (1015 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground. [ECTCR UFAS 4.25.3, Fig. 38]...
-
5.4.4.2 Transfer Support Distance from Transfer Surface for Imaging Equipment
Supports (transfer or positioning) should be located 1 ½ inches maximum from the transfer surface....
-
R408.2 Treads and Risers
Risers shall be 100 mm (4 in) high minimum and 180 mm (7 in) high maximum. Treads shall be 280 mm (11 in) deep minimum....
-
C1-d
[ADA Standards § 4.3.8] Yes No Note: Level changes between 1/4 inch and 1/2 inch should be beveled (sloped) at 1:2 maximum....
-
R406.2 Unobstructed Forward Reach
Where a forward reach is unobstructed, the high forward reach shall be 1220 mm (4.0 ft) maximum and the low forward reach shall be 380 mm (1.25 ft) minimum above the finish surface....
-
Check-Out Areas [8.3]
Check-Out Areas [8.3] Check-out counters at accessible lanes are held to a maximum surface height of 36 inches....
-
505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (865 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
-
7.2 SERVICE COUNTERS
exceeding 36 in (915 mm) in height are provided for standing sales or distribution of goods to the public, an auxiliary counter or a portion of the main counter shall be provided with a maximum...
-
Public Sector (Government) Facilities
subject to title II of the ADA except those with no more than two stories where the inaccessible story above (or below) the entry level has no public use space and an occupant load of five maximum...
-
504.2 Treads and Risers
Risers shall be 4 inches (100 mm) high minimum and 7 inches (180 mm) high maximum. Treads shall be 11 inches (280 mm) deep minimum....
