A building or facility, or portion thereof, used for the purpose of entertainment, educational or civic gatherings, or similar purposes....
Search Results "Fire-Building Surface"
Filters
Commonly Searched Documents
-
Assembly Area
-
1.1.10 Availability of codes
At least one complete copy each of Titles 8, 19, 20, 24, and 25 with all revisions shall be maintained in the office of the building official responsible for the administration and enforcement...
-
5.4.1.2 Transfer and Positioning Support Location for Imaging Equipment
Transfer supports should be provided for imaging equipment with transfer surfaces with depths of less than or equal to 24 inches....
-
Cal-Royal 900 Series Hydraulic Door Closers
Cal-Royal’s Finest Hydraulic Door Closer Series Meeting The Highest Industry Standards, Grade 1 Heavy-Duty Full Feature Multi-Size Commercial Door Closer For Use In Office Buildings...
-
ADA Requirements
The Standards require lodging facilities to install visual fire alarms and to have rooms that are equipped for persons who are deaf or hard of hearing....
-
1.1.3.2, Item 9
Permanent buildings and permanent accessory buildings or structures constructed within mobile-home parks and special occupancy parks regulated by the Department of Housing and Community...
-
1.2 Compliance with New Construction Requirements
1.2 Compliance with New Construction Requirements: The basic work of any project, whether new construction, an addition to an existing building or facility or an alteration of an existing...
-
Edge Protection
Edge Protection Where railings, guards, or handrails are provided, edge protection must be provided and extend a minimum of 2 inches above the ground or deck surface....
-
22. How can I get copies of the ASTM standards that apply to play areas?
American Society for Testing and Materials, 100 Bar Harbor Drive, West Conshohocken, Pennsylvania 19428, www.astm.org: ASTM F 1292-99 Standard Specification for Impact Attenuation of Surface...
-
SEAT HEIGHT MEASUREMENT DETAIL
Note that examination tables and chairs only use bolsters on certain areas of the transfer surface....
-
1.3.2 Focus Following NPRM Comments
This review identified four major issue areas for the MDE Advisory Committee to address, as follows: Transfer surface height and size Permitted obstructions to the transfer surface...
-
I. Public Toilet Rooms
In all public and common use toilet rooms throughout the Hotel and the Tower, Defendants will provide at least one lavatory with a counter-top that is 34 inches above the finish floor surface...
-
Card Catalogs and Magazine Displays [8.4]
Requirements for fixed counters and tables [4.32] specify a surface height (34 inches maximum) and knee clearance below appropriate for extended use as a writing/work surface....
-
Safe Harbors
As observed in the Background section of this Introduction, a Building Code changes constantly, so "the immediately preceding edition of the California Building Code" is subject to interpretation...
-
IMPLICATION OF A 19-INCH MINIMUM STANDARD FOR THE HIGHEST POINT IN THE LOWEST ADJUSTABLE POSITION
However, shorthand references to 19 inches as the minimum standard as used in this minority report should not be equated with a 19-inch transfer surface height, for two major reasons....
-
¼ Inch Minus Limestone
The surface was installed in two rolled and compacted 3 inch lifts....
-
Areas for further work
Areas for further work In the process of assisting the various organizations that represent surface materials and professional groups the following issues were identified as parameters...
-
F207.1 General
Means of egress shall comply with section 1003.2.13 of the International Building Code (2000 edition and 2001 Supplement) or section 1007 of the International Building Code (2003 edition...
-
1.9.1.8 Adopting agency identification
The provision of this code applicable to buildings identified in this Subsection 1.9.1 will be identified in the Matrix Adoption Tables under the acronym DSA-AC....
-
Alteration
An alteration is a change to a building or facility made by, on behalf of or for the use of a public accommodation or commercial facility, that affects or could affect the usability of the...
-
1.9.1.8 Adopting agency identification
The provision of this code applicable to buildings identified in this Subsection 1.9.1 will be identified in the Matrix Adoption Tables under the acronym DSA-AC....
-
1.9.1.8 Adopting agency identification
The provisions of this code applicable to buildings identified in this Subsection 1.9.1 will be identified in the Matrix Adoption Tables under the acronym DSA-AC....
-
a) Enforcement
A Building Code is enforced by governmental authorities having jurisdiction (AHJs), who are empowered to interpret and/or modify its requirements. ...
-
Enforcement
A Building Code is enforced by governmental authorities having jurisdiction (AHJs), who are empowered to interpret and/or modify its requirements. ...
