that is easy to grasp with one hand and does not require tight grasping and twisting actions of the wrist to operate at the following locations: (1) Main Lobby men's and women's toilet stall...
Search Results "Alternate Stall"
Filters
Commonly Searched Documents
-
d. ii.
-
Water Closets [4.16]
Water Closets [4.16] Accessible water closets, including those located in stalls, must comply with the requirements in 4.16....
-
7(2)(b)(vii)
(vii) Stall showers in the bathroom may be of any size or configuration. A minimum clear floor space 2'6" wide by 4'0" should be available outside the stall. (See Figure 7(d).)...
-
AJW Architectural Products U683 Dual Stall Toilet Tissue Dispenser & Sanitary Napkin Disposal - Partition Mounted
Product Features Fabricated of #22 gauge stainless steel with a #4 satin finish Holds two standard toilet tissue rolls Waste receptacle has a 1 gallon capacity Product...
-
AJW Architectural Products U852H Dual Stall Seat Cover Dispenser w/ Flush Mounting - Partition Mounted
Product Features Fabricated of #22 gauge stainless steel with a #4 satin finish Holds 500 seat covers Seat cover dispenser is partition mounted Product Specs Body:...
-
Showers
The final Guidelines for usable bathrooms (the first set of specifications) specify size dimensions for shower stalls in only one situation -- when the shower stall is the only bathing facility...
-
General Partitions ADA Hook (HCH-1)
Holes) (ADA Stalls)...
-
4.34.5.5(1) Size and clearances
Shower stall size and clear floor space shall comply with either Fig. 35(a) or (b). The shower stall in Fig. 35(a) shall be 36 in by 36 in (915 mm by 915 mm)....
-
4.21.1* GENERAL
Accessible shower stalls shall comply with 4.21. For shower stalls in accessible dwelling units, see 4.34.5.5....
-
4.21.3 Seat
A seat shall be provided in shower stalls 36 in by 36 in (915 mm by 915 mm) and shall be as shown in Fig. 36....
-
1134A.6, Item 1
When one or more shower stalls are provided within the same dwelling unit, at least one shower stall shall comply with one of the following requirements....
-
1134A.6, Item 1
When one or more shower stalls are provided within the same dwelling units, at least one shower stall shall comply with one of the following requirements....
-
4.23.4 WATER CLOSETS
If toilet stalls are provided, then at least one shall comply with 4.17; its water closet shall comply with 4.16....
-
4.22.4 WATER CLOSETS
If toilet stalls are provided, then at least one shall comply with 4.17; its water closet shall comply with 4.16....
-
Error/Omission: When a transfer shower is used, it is often larger than the required 36" x 36" size.
Except as specified in 9.1.2, shower stall size and clear floor space shall comply with Fig. 35(a) or (b). The shower stall in Fig. 35(a) shall be 36 in by 36 in (915 mm by 915 mm)....
-
7(2)(a)(iii)
(iii) If the shower stall is the only bathing facility provided in the covered dwelling unit, or on the accessible level of a covered multistory unit, the shower stall measures at least...
-
11B-502.4 Floor or ground surfaces
Where two parking stalls share the same access aisle, a full depth aisle is required; in diagonal parking, the geometric layout will require additional access aisle depth to satisfy the...
-
11B-809.10.6.4 Reinforcement for grab bars
Glass-walled shower stalls shall provide reinforcement for installation of floor-mounted or ceiling-mounted grab bars....
-
H16
Is the toilet stall at least 60 inches wide and 56 inches deep (wall mounted toilet) or 59 inches deep (floor mounted toilet)?...
-
4.17.4 Toe Clearances
In standard stalls, the front partition and at least one side partition shall provide a toe clearance of at least 9 in (230 mm) above the floor....
-
4.21.7 CURBS
If provided, curbs in shower stalls 36 in by 36 in (915 mm by 915 mm) shall be no higher than 1/2 in (13 mm)....
-
4.17.4 TOE CLEARANCES
In standard stalls, the front partition and at least one side partition shall provide a toe clearance of at least 9 in (230 mm) above the floor....
