This section contains the technical requirements for the length (1017.8.1), width (1017.8.2), and slope (1017.8.3) of resting intervals; and for a turning space (1017.8.4) where resting...
Search Results "Technical Requirement"
Filters
Commonly Searched Documents
-
1017.8 Resting Intervals
-
§382.57(c)
(c) You must ensure that the automated airport kiosks provided in accordance with this section conform to the following technical accessibility standards with respect to their physical design...
-
TECHNICAL QUESTIONS:
[See subsections ...]
-
Compliance Requirements in Final Rule
The final rule contains scoping and technical requirements for camping facilities, picnic facilities, viewing areas, trails, and beach access routes....
-
Components (R302.2) (Section-by-Section Analysis)
Components (R302.2) (Section-by-Section Analysis) The components of pedestrian access routes and the technical requirements for each component are listed in R302.2....
-
R301 General (Section-by-Section Analysis)
R301 General (Section-by-Section Analysis) The technical requirements in Chapter R3 apply where required by the scoping requirements in Chapter R2, or where referenced by another technical...
-
1017.1 General
This section contains the technical requirements for trails....
-
5.3 Pit Toilets
[See subsections ...]
-
5.1 Camp Shelters
[See subsections ...]
-
E. What are the General Requirements for Curb Ramps in the ADA Standards for Accessible Design?
One way to make curb ramps compliant with Title II of the ADA is to build them in accordance with the ADA Standards. 7 Following are the key characteristics of an accessible curb...
-
M101.3 Existing Diagnostic Equipment
The MDE Standards do not address the applicability of scoping or technical requirements to existing diagnostic equipment....
-
B.2.ii. - How should an agency proceed in identifying "applicable" technical provisions in Subparts B, C, and D of the Access Board’s standards to ensure acquired products provide comparable access?
Agencies should first look to the provisions in Subpart B to determine if there are specific technical provisions that apply to the EIT need they are seeking to satisfy....
-
D. Functional Performance Criteria and Technical Requirements (Section-by-Section Analysis)
Appendix C sets forth proposed functional performance criteria (Chapter 3) and technical requirements (Chapters 4 through 6) that are referenced by, and applied in, the Application and Scoping...
-
M101.3 Existing Diagnostic Equipment (Section-by-Section Analysis)
Specifically, at the public hearing on March 14, 2012, two commenters recommended phasing in these requirements for imaging equipment based on when it is replaced....
-
M101.1 Purpose (Section-by-Section Analysis)
The MDE NPRM proposed that the purpose of the MDE Standards was to establish technical criteria for diagnostic equipment that is accessible to and usable by patients with disabilities and...
-
Technically Infeasible
With respect to an alteration of a building or a facility, something that has little likelihood of being accomplished because existing structural conditions would require removing or altering...
-
4.3 Tent Pads and Tent Platforms
[See subsections ...]
-
3. If I comply with the California accessibility requirements, am I in compliance with ADA?
requirements AND the federal requirements under the ADA....
-
TECHNICALLY INFEASIBLE
[DSA-AC] An alteration of a building or a facility, that has little likelihood of being accomplished because the existing structural conditions require the removal or alteration of a load-bearing...
-
3. Relationship between Functional Performance Criteria and Technical Provisions
Over the years, agencies and other stakeholders had expressed confusion concerning the interaction between the technical requirements and functional performance criteria in the existing...
-
§ 382.57(c)
(c) You must ensure that the automated airport kiosks provided in accordance with this section conform to the following technical accessibility standards with respect to their physical design...
-
Trails
[See subsections ...]
-
5.3.3.2 Location Where Walls Provided
Where walls or partitions are provided, the seat shall be positioned with a wall or partition to the rear and to one side of the seat for a left-hand or right-hand approach. The back...
-
1016.1 General
This section contains the technical requirements for outdoor recreation access routes....