Where more than one parking facility is provided on a site, the number of accessible spaces provided on the site shall be calculated according to the number of spaces required for each parking...
Search Results "Photometric Calculation"
Filters
Commonly Searched Documents
-
11B-208.2 Minimum number
-
Must the minimum number of spaces be determined separately for each parking facility on a site or can it be based on the collective total of spaces provided on a site?
The minimum number of accessible parking spaces, including van accessible spaces, must be calculated separately for each parking facility on a site....
-
11B-233.3.1.2.5 Multi-story residential dwelling units in buildings with no elevator
In non-elevator buildings, a minimum of 10 percent but not less than one of the ground floor multi-story residential dwelling units shall be calculated using the total number of multi-story...
-
2.3.1. Hardware Acquisition
Captioning and audio description hardware acquisition is calculated and presented separately in the Final RA....
-
2.3.2. Device Acquisition
Similar to hardware acquisition, the methodology used for the device acquisition calculation is identical for both captioning and audio description devices. ...
-
11B-233.3.1.2.6.3 Test number two, site analysis test
Calculate the percentage of the total buildable area of the undisturbed site with a natural grade less than 10 percent slope....
-
1. Introduction
Chapter 2 presents an overview of the methodology for calculating the costs attributed to the final rule and how the methodology is applied for calculating the costs for all movie theaters...
-
Data Analysis
For protocols A, B and C percentages were calculated for the space needed to transfer to and from the transfer station....
-
Appendix: FSTAG Implementation Process Flowchart
Step 1: Determine Applicability of FSTAG Step 2: Identifiy Presence of Limiting Factors Step 3: Apply Technical Provisions Step 4: Calculate Cumulative Percentage...
-
3. Data Overview
Sections 3.1 through 3.5 explain the data and assumptions used to calculate the upfront costs of equipment acquisition and installation. ...
-
§ 37.131(c)(1)
(1) In calculating the full fare that would be paid by an individual using the fixed route system, the entity may include transfer and premium charges applicable to a trip of similar length...
-
Door and Signal Timing: ADA Standard Section 407.3.4
Section 407.3.4 covers the current ADA Standards for door and signal timing of elevator reopening devices.
-
11B-407.3.4 Door and signal timing
The minimum acceptable time from notification that a car is answering a call until the doors of that car start to close shall be calculated from the following equation: T = D/(1.5 ft/...
-
1009.6.3 Size
The total number of such 30-inch by 48-inch (762 mm by 1219 mm) spaces per story shall be not less than one for every 200 persons of calculated occupant load served by the area of refuge...
-
Pedestrian Signal Phase Timing (Section-by-Section Analysis)
Pedestrian Signal Phase Timing (Section-by-Section Analysis) Pedestrian signal phase timing must comply with referenced MUTCD standards and use a pedestrian clearance time that is calculated...
-
FULL AND FAIR CASH VALUE
Full and fair cash value is calculated for the estimated date on which work will commence on a project and means: (1) The assessed valuation of a building or facility as recorded in the...
-
1.1.11 Ramp running slope
Measure for overall running slope of ramps by determining elevations at the top and bottom of the ramp at the midpoint of the width of each ramp run and calculate the slope using the horizontal...
-
2.4. Ongoing Costs
The Final RA calculates three types of ongoing annual costs: Replacement Costs; Training Costs; and Maintenance and Administrative Costs....
-
Station 6-Speed
Speed is also used in calculating necessary sight distances....
-
New Requirements for Assistive Listening Systems (ALS)
Calculate the additional receivers using the chart above. Always round up....
-
Self Contained, Closed Products
These products include, but are not limited to, information kiosks and information transaction machines, copiers, printers, calculators, fax machines, and other similar types of products...
-
5. ANNUAL ADJUSTMENT OF COST THRESHOLDS:
Annual adjustments are calculated using the first January issue of Engineering News-Record’s U.S. 20 City Construction Cost Index....
-
R306.2 Pedestrian Signal Phase Timing
All pedestrian signal phase timing shall comply with section 4E.06 of the MUTCD (incorporated by reference, see R104.2) and shall be based on a pedestrian clearance time that is calculated...
-
§382.131 Do baggage liability limits apply to mobility aids and other assistive devices?
The basis for calculating the compensation for a lost, damaged, or destroyed wheelchair or other assistive device shall be the original purchase price of the device....