Operable parts shall be operable with one hand and shall not require tight grasping, pinching, or twisting of the wrist....
Search Results "Operation (Control)"
-
309.4 Operation
-
§ 1194.31(f)
(f) At least one mode of operation and information retrieval that does not require fine motor control or simultaneous actions and that is operable with limited reach and strength shall be...
-
Maximum Force
The Board sought comment on whether the maximum 5 pounds of force was appropriate for operating controls activated by a single finger, such as elevator call and control panel buttons, platform...
-
Handles, Pulls, and Knobs
Knobs that require a full hand grip and turning, including round door knobs and shower controls, do not comply because they require twisting of the wrist....
-
Must operable parts be usable with a closed fist?
Closed-fist operation is a good performance test but is not required by the standards....
-
Are turn-key locks prohibited by the standards?
Key locks or key cards are not prohibited by the standards which apply only to the fixed portions of operable parts....
-
K5
If the operating controls are set back 10 to 24 inches from the front edge of the counter or table are they no higher than 46 inches above the floor?...
-
T304 Operable Parts
The technical requirements for operable parts include provisions on height, location, and operation....
-
309.4 Operation
309.4 Operation. Operable parts shall be operable with one hand and shall not require tight grasping, pinching, or twisting of the wrist....
-
Are locks operated by keys prohibited due to the pinching or twisting of the wrist their operation typically requires?
No, non-fixed portions of door or gate hardware, including keys and access cards, are not covered by the Standards, but those that can be used without pinching or turning will...
-
R403.4 Operation
R403.4 Operation. Operable parts shall be operable with one hand and shall not require tight grasping,pinching, or twisting of the wrist....
-
4.3.8 Operating forces
Further, tasks and products that require operation of controls or object grasping should allow for both right and lefthanded operation, given that more than 25% of wheeled mobility device...
-
Reach Ranges and Operable Parts
REACH RANGES AND OPERABLE PARTS Forward and side reach 11B-308.2/3 Over projections 11B-308.2.2/3.2...
-
Reach Ranges and Operable Parts
REACH RANGES AND OPERABLE PARTS Forward and side reach 11B-308.2/3 Over projections 11B-308.2.2/3.2...
-
Operation
The controls and operating mechanisms must be unobstructed when a lift is in use....
-
309.4 Operation
Operable parts shall be operable with one hand and shall not require tight grasping, pinching, or twisting of the wrist....
-
Hardware [4.25.4]
Hardware [4.25.4] Hardware should be exposed (as required for sliding doors in 4.13) and must: be automatic or operable with one hand operate without tight grasping,...
-
Operation [4.27.4]
Operation [4.27.4] Controls and operating mechanisms must: be automatic or operable with one hand operate without tight grasping, pinching, or twisting of the wrist...
-
Pay Stations
Require-ments [sic] for operable parts cover clear floor space, operating characteristics, and location within accessible reach ranges....
-
T704.2 Stop Request Systems
Stop request systems shall comply with T704.3.
-
T704.2.2 Operation
Operable parts on stop request systems shall comply with T304....
-
407.9 Operation (Section-by-Section Analysis)
407.9 Operation (Section-by-Section Analysis) This section would require ICT with operable parts to provide at least one mode of operation that is operable with one hand, and prohibits...
-
Water Hydrants
Standard handpumps require a force greater than 5 pounds (2.2 newtons) and a long reach to operate....
-
Operation: ADA Standard Section 309.4
Section 309.4 covers the current ADA Standards for the operation of operable parts....