Bus route identification signs shall comply with Sections 11B-703.5.1 through 11B-703.5.4, and Sections 11B-703.5.7 and 11B-703.5.8....
Search Results "Bus Rapid Transit"
-
11B-810.4 Bus signs
-
11B-810.4 Bus signs
Bus route identification signs shall comply with Sections 11B-703.5.1 through 11B-703.5.4, and Sections 11B-703.5.7 and 11B-703.5.8....
-
§ 38.173(d)
(d) Light rail and rapid rail AGT vehicles and systems shall comply with subparts D and C of this part, respectively....
-
11B-406.1.3 Blended transitions
Blended transitions shall comply with Section 11B-406.4....
-
11B-406.1.3 Blended transitions
Blended transitions shall comply with Section 11B-406.4....
-
R213 Transit Stops and Transit Shelters
R213 Transit Stops and Transit Shelters. Where provided, transit stops and transit shelters shall comply with R308. Advisory R213 Transit Stops and Transit Shelters....
-
11B-406.4 Blended transitions
Blended transitions shall comply with Sections 11B-406.4 and 11B-406.5....
-
11B-406.4 Blended transitions
Blended transitions shall comply with Sections 11B-406.4 and 11B-406.5....
-
R213 Transit Stops and Transit Shelters (Section-by-Section Analysis)
R213 Transit Stops and Transit Shelters (Section-by-Section Analysis) Transit stops and transit shelters must comply with the technical requirements for transit stops and transit shelters...
-
11B-810.3 Bus shelters
Bus shelters shall provide a minimum clear floor or ground space complying with Section 11B-305 entirely within the shelter....
-
11B-810.3 Bus shelters
Bus shelters shall provide a minimum clear floor or ground space complying with Section 11B-305 entirely within the shelter....
-
Subpart C—Rapid Rail Vehicles and Systems
[See subsections ...]
-
Bus Shelter Benches
John, I cannot find anything that says that benches in bus shelters must comply with the bench requirements in 903. ...
-
11B-247.1.2.4 Bus stops
Where detectable warnings are provided at bus stop boarding and alighting areas in compliance with Section 11B-810.2.3, detectable warnings shall comply with Sections 11B-705.1.1 and 11B...
-
11B-247.1.2.4 Bus stops
Where detectable warnings are provided at bus stop boarding and alighting areas in compliance with Section 11B-810.2.3, detectable warnings shall comply with Sections 11B-705.1.1 and 11B...
-
Figure 810.2.2 Dimensions of Bus Boarding and Alighting Areas – Drawing from the U.S. Access Board
-
11B-705.1.2.4 Bus stops
When detectable warnings are provided at bus stop boarding and alighting areas, the detectable warnings shall extend the full width of the boarding/alighting area and shall be 36 inches...
-
11B-705.1.2.4 Bus stops
When detectable warnings are provided at bus stop boarding and alighting areas, the detectable warnings shall extend the full width of the boarding/alighting area and shall be 36 inches...
-
Level boarding
If not using a lift or ramp to provide level boarding, the grantee must submit to FTA a demonstration of equivalent facilitation. (DOT ADA Regulation 49 C.F.R. 37.7(b) and DOT ADA...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
11B-810.2.3 Connection
Bus stop boarding and alighting areas shall be connected to streets, sidewalks, or pedestrian paths by an accessible route complying with Section 11B-402....
-
11B-810.2.3 Connection
Bus stop boarding and alighting areas shall be connected to streets, sidewalks, or pedestrian paths by an accessible route complying with Section 11B-402....
-
Section 37.121 Requirement for Comparable Complementary Paratransit Service
This requirement applies to light and rapid rail systems as well as to bus systems, even when rail and bus systems share all or part of the same service area....
