Every dwelling unit on a floor served by an elevator must be on an accessible route, and must be made accessible in accordance with the Act's requirements for covered dwelling units....
Search Results "Floor Identification"
-
(1) Site impracticality
-
11B-703.5.5 Character height
Exception: Where provided, floor plans providing emergency procedures information in accordance with Title 19 shall not be required to comply with Section 11B-703.5.5....
-
1011.2.1 Size and Location
The size of the clear ground space is based on the dimensions for maneuvering clearance at clear floor or ground spaces that are confined on all or part of three sides in 305.7 of the Architectural...
-
11B-703.5.5 Character height
Exception: Where provided, floor plans providing emergency procedures information in accordance with Title 19 shall not be required to comply with Section 11B-703.5.5....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
11B-608.6 Shower spray unit and water
One shower head shall be located at a height of 48 inches (1219 mm) maximum above the shower finish floor....
-
11B-703.5.5 Character height
Exception: Where provided, floor plans providing emergency procedures information in accordance with Title 19 shall not be required to comply with Section 11B-703.5.5....
-
11B-608.6 Shower spray unit and water
One shower head shall be located at a height of 48 inches (1219 mm) maximum above the shower finish floor....
-
ALIGNMENT OF 19-INCH RECOMMENDATION WITH ACCESS BOARD PROPOSED RULEMAKING
proposed rule, the Access Board proposed that the “height of the transfer surface during patient transfer shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured from the floor...
-
I. Background
to the required height in all restrooms where located; accessible signs in accessible locations have been mounted at doors at exit passageways, exit discharge, and exit stairways; room identification...
-
SDC Bollard Post with Push Plate or Touch Panel
Panel Columns & Exit Switches 6” square with 1/8” walls Black HDPE mortised removable cap with secure transmitter mount Standard single gang prep located at 36” from finished floor...
-
Access-Able Designs Child Dressing Bench CH-101
Stainless steel frame holds up to 500 lbs. with proper mounting and sufficient flooring (ADA 4.26.3 is only 250 lbs.) Complies w/ ADA 4.21.3 when properly installed....
-
ADDENDUM TO PHASE I FINAL REPORT: Points of Clarification
One subject could not transfer higher or lower than their device's seat to floor height. ...
-
ASI Global Partitions High Density Polyethylene Solid Plastic Toilet Partitions
Vandal-Resistant Fasteners Special driver installs fasteners which virtually eliminates unauthorized removal and ensures easy installation. 55” High Doors and Panels 14” clearance from floor...
-
Hoyer Presence Heavy-Duty Lift
With its outstanding lift range, the Presence can accommodate lifts from the floor, as well as transfers to higher surfaces....
-
Cybex Total Access Leg Extension Exercise Machine
This allows fitness enthusiasts who have physical or sensory limitations to take advantage of fitness training on the same gym floor and using the same equipment as those who do not....
-
Height Requirements
revised to specifically cover operable parts that are "intended for use only by service or maintenance personnel," "electrical or communication receptacles serving a dedicated use," and "floor...
-
1132A.5.1 General
The floor or landing on the dwelling unit side of the primary entry door and any required exit door shall have a minimum length of not less than 44 inches (1118 mm)....
-
106 Definitions
unnecessary, in most cases due to changes in certain scoping or technical requirements: "accessible route," "area of refuge," "automatic door," "destination-oriented elevator," "ground floor...
-
18. Where an existing ground level play component is replaced, should the new component comply with the technical provisions of Section 1008.4 even if there is not an accessible route to it?
In this case, the spring rocker being replaced would need to have the rocker seat height between 11 and 24 inches and clear floor or ground space and maneuvering space provided adjacent...
-
1007.1 Accessible means of egress required
In assembly spaces with sloped floors, one accessible means of egress is required from a space where the common path of travel of the accessible route for access to the wheelchair spaces...
-
16. If a play surface is replaced with an accessible surface and the existing ground level play components are not accessible, do the components need to be replaced?
If the alteration to the play area only involves the surfacing, only the surface along accessible routes, clear floor or ground spaces, and maneuvering spaces must comply with the ASTM F...
-
4.3.11.2 Size
EXCEPTION: The appropriate local authority may reduce the minimum number of 30-inch by 48-inch (760 mm by 1220 mm) areas to one for each area of rescue assistance on floors where the occupant...
-
General [9.1.1]
Objects with leading edges above 27 inches and below 80 inches above the floor cannot project more than 4 inches unless there is a tactile cane detectable cue below the object....
