(a) The purpose of this part is to effectuate section 504 of the Rehabilitation Act of 1973, as amended (29 U.S.C 794), to the end that no otherwise qualified individual with handicaps in...
Search Results "End Transfer Surface"
-
§8.1(a)
-
20.1 Q. If a covered multifamily dwelling has an individual, private garage which is attached to and serves only that dwelling, does the garage have to be accessible in terms of width and length?
14(c) addresses parking garages where there are several garages or stalls located together, either in a separate, detached building, or in a central area of the building, such as at one end...
-
A.2.i. - What does Section 508 require?
508 generally requires Federal agencies to ensure that, when developing, procuring, maintaining, or using electronic and information technology, they take into account the needs of all end...
-
Grab Bars [4.16.4]
It must be 36 inches long minimum, installed with one end space a maximum of 6 inches from the side wall....
-
R308.2 Transit Shelters
Where seating is provided within transit shelters, the clear space shall be located either at one end of a seat or shall not overlap the area within 460 mm (1.5 ft) from the front edge of...
-
15(c)
Any unresolved disputes under this section may be submitted by either Party to the Court within 30 days after the dispute resolution period ends....
-
Bobrick Double Robe Hook B-672
Contoured 4" (100mm) wide bar forms hook at each end. Flange is 2" x 2" (50 x 50mm). Projects 2 5⁄16" (60mm) from wall....
-
§382.7(b)
(b) If you are a foreign carrier, this part applies to you only with respect to flights you operate that begin or end at a U.S. airport and to aircraft used for these flights....
-
4.3.5.2 180-degree turn
These data are based on measurements of wheeled mobility users performing 180-degree turns in a dead-end hallway, built with mock walls....
-
Door King Inc. 1812 Access Plus Communication System
Surface mount dimensions: 6.13"H x 10"W x 5.25"D. Surface curved mount dimensions: 7.38 "H x 10.88"W x 6"D Flush mount dimensions: 9.13"H x 11.88"W x 4.5"D....
-
1012.5 Slope
The slope of the surface of parking spaces and pull-up spaces shall not be steeper than 1:48 in any direction....
-
904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
5.1.8 Slope
The slope of the surface of the clear ground space shall not be steeper than 1:48 in any direction....
-
1012.5 Slope
The slope of the surface of parking spaces and pull-up spaces shall not be steeper than 1:48 in any direction....
-
GUARD OR GUARDRAIL
A building component or a system of building components located at or near the open sides of elevated walking surfaces that minimizes the possibility of a fall from the walking surface to...
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
CURB RAMP
A sloping prepared surface, intended for pedestrian traffic, which provides access between a walk or sidewalk and a surface located above or below an adjacent curb face....
-
11B-303.5 Warning curbs
Abrupt changes in level exceeding 4 inches (102 mm) in a vertical dimension between walks, sidewalks or other pedestrian ways and adjacent surfaces or features shall be identified by warning...
-
Openings [1018.6]
Openings are gaps in the surface of a beach access route....
-
Outdoor Conditions [4.8.8]
Exterior ramps must be designed so that water does not accumulate on the ramp or landing surface. A slope up to 2% is allowed at landings for adequate drainage....
-
APPENDIX C
What was your pain/discomfort value associated with this surface (circle)?...
-
1011.4 Picnic Tables
This section requires picnic tables to comply with the technical requirements for dining surfaces in 902.3 of the Architectural Barriers Act Accessibility Guidelines, which requires the...
