AL) and Duro (DU) stock finishes, other upon request Warranty 25 years limited Code Compliance ANSI/BHMA A156.4 Grade 1 Certified UL UL &ULC Listed BAA BAA model meets guidelines...
Search Results "Design Guideline"
Filters
Commonly Searched Documents
-
TownSteel TDC 85 ALUMINUM Grade 1 Door Closer
-
Bradley Security Grab Bars SA70 Series
Strength: When properly mounted, all Bradley heavy duty grab bar systems meet or exceed the requirements of ANSI Standard A117.1, the ADA and ABA Accessibility Guidelines for Buildings and...
-
11B-233.1 General
(emphasis added) must be designed and constructed so that it is “readily accessible to and useable by individuals with disabilities....
-
Interdisciplinary Communication and Vocabulary
think is so exciting about where he’s going with this is addressing a little bit of the gap analysis that we talked about yesterday, that the physics in terms of parameters that we can design...
-
§ 36.401(d)(1)(ii)(B)
The facility housing a "shopping center or shopping mall" only includes floor levels housing at least one sales or rental establishment, or any floor level designed or intended for use by...
-
11B-803.1 General
Partitions and doors should be designed to ensure people using accessible dressing and fitting rooms privacy equivalent to that afforded other users of the facility....
-
Section 36.406(f)(2)
This rule, which is designed to prevent a public accommodation from placing wheelchair spaces and companion seats on one side of the facility only, is consistent with the Department’s enforcement...
-
Q7: Curb Ramp for a Sidewalk that is Not Made of Concrete or Asphalt
Regardless of the materials used to construct the pedestrian walkway, if the intent of the design was to provide access to pedestrians, then curb ramps must be incorporated where an altered...
-
1132A.8 Hand-activated door hardware
locking doors that are hand-activated and on an accessible route shall be operable with a single effort by lever-type hardware, panic bars, push-pull activating bars or other hardware designed...
-
Lines of Sight at Dining Areas in Sports Venues
Designers called attention to dining areas integrated into the seating bowl of sports venues that are tiered in order to provide adequate lines of sight....
-
Height
This will allow a design professional to increase the guardrail height if a specific location needs enhanced safety measures or a local building code applies....
-
Transfer Height
Where possible, designers are encouraged to locate the transfer device seat within 17 to 19 inches above the load and unload surface....
-
1.2 MDE Advisory Committee Membership
Table 1.2 lists the 24 organizations selected; each organization could designate a primary representative and a secondary representative who would participate in the absence of (or at the...
-
R304.5.3 Cross Slope
Pedestrian street crossings without yield or stop control are crossings where there is no yield or stop sign, or where there is a traffic signal that is designed for the green phase....
-
R101.1 General
Compliance with this document is mandatory when required by regulations issued by federal agencies that include accessibility standards for the design, construction, and alteration of pedestrian...
-
J. Valet Parking and New Parking Garage
construct accessible parking spaces, entrances, and routes of travel as required by 2010 Standards §§ 208.1, 208.2, 208.2.4, 208.3.1, and 502.1-503.5, and to erect appropriate signage designating...
-
ADA Requirements - Wheelchairs, Mobility Aids, and Other Power-Driven Mobility Devices
These requirements, or rules, clarify and refine issues that have arisen over the past 20 years and contain new, and updated, requirements, including the 2010 Standards for Accessible Design...
-
Sec.36.401(d)(1)(ii)(B)
The facility housing a "shopping center or shopping mall'' only includes floor levels housing at least one sales or rental establishment, or any floor level designed or intended for use...
-
Outdoor Conditions [4.8.8]
Exterior ramps must be designed so that water does not accumulate on the ramp or landing surface. A slope up to 2% is allowed at landings for adequate drainage....
-
Measuring Opening Force
While there are instruments specifically designed for this purpose (e.g., tensionometer), a device as simple as a spring-loaded plunger or "fish" scale is effective in measuring the force...
-
Equivalent Facilitation [2.2]
This provides flexibility for new technologies and innovative designs solutions that may not have been taken into account when ADAAG was developed....
-
Definitions
“Accessible on Election Day” means that a polling place is compliant with the 2010 ADA Standards for Accessible Design (“2010 Standards”) on Election Day, whether such compliance is...
-
On-Site Readers
If this happens, designate people to serve as on-site readers....
