The Guidelines are intended to provide a safe harbor for compliance with the accessibility requirements of the Fair Housing Amendments Act, as implemented by 24 CFR §100.205 of the Department's...
Search Results "ADA Compliance"
-
The Guidelines are not mandatory
-
§8.21(c)(2)(i) General
A recipient is not required to make structural changes in existing facilities where other methods are effective in achieving compliance with this section....
-
QUESTION: WHERE THE TRACK ADJACENT TO A PLATFORM IS NOT SHARED WITH FREIGHT, ARE THERE ANY CIRCUMSTANCES IN WHICH AN APPROACH OTHER THAN LEVEL BOARDING IS ALLOWABLE?
The Department views compliance with the requirements of the rule on a station-by-station basis....
-
Regulatory Flexibility Act
However, the bulk of paratransit operators are not small entities, and the majority of all paratransit operators already appear to be in compliance....
-
[A] 101.4.5 Fire prevention
ETA Editor's Note Sections from California Building Code Chapter 1 not adopted by Division of the State Architect - Access Compliance (DSA-AC) omitted. ...
-
238.2.1 Teeing Grounds
courses, the forward teeing ground shall not be required to be one of the teeing grounds on a hole designed and constructed so that a golf car can enter and exit the teeing ground where compliance...
-
11B-404.3.2 Maneuvering clearance
Exception: Where automatic doors and gates remain open in the power-off condition, compliance with Section 11B-404.2.4 shall not be required....
-
235.2.1 Dispersion
For example, a fuel pier may contain boat slips, and this type of short term slip would be included in determining compliance with 235.2....
-
§35.150(b)(1)
A public entity is not required to make structural changes in existing facilities where other methods are effective in achieving compliance with this section....
-
210 Stairways
New: Compliance for all stairs that are part of a means of egress. Exceptions are new....
-
IV. Discussion of Findings and Implications
A playground surface with poured-in-place rubber had a use zone found in non-compliance with the ASTM standard for impact attenuation. ...
-
[A] 101.4.5 Fire prevention
ETA Editor's Note Sections from the California Building Code Chapter 1 that are not adopted by the Division of the State Architect - Access Compliance (DSA-AC) have been omitted....
-
11B-404.3.2 Maneuvering clearance
Exception: Where automatic doors and gates remain open in the power-off condition, compliance with Section 11B-404.2.4 shall not be required....
-
11B-404.3.2 Maneuvering clearance
Exception: Where automatic doors and gates remain open in the power-off condition, compliance with Section 11B-404.2.4 shall not be required....
-
11B-705.1.2.2.2.1 One entrance/exit point
Existing parallel curb ramps with detectable warnings in compliance with the code requirements in effect at the time of installation shall not be required to provide a minimum 36 inches...
-
11B-809.10.2 Number of complying bathing rooms and fixtures
Where two or more bathrooms are provided, when a bathtub is installed in the first bathroom in compliance with Section 11B-809.10.5 and a shower compartment is provided in a subsequent bathroom...
-
101.4.5 Fire prevention
ETA Editor's Note Sections from the California Building Code Chapter 1 that are not adopted by the Division of the State Architect - Access Compliance (DSA-AC) have been omitted....
-
B. The Legal Landscape
Before looking at the individual parts of the ADA, it’s best to look at the whole picture....
-
5.5(b) The Job Application Form
5.5(b) The Job Application Form A review of job application forms should be a priority before the ADA's effective date, to eliminate any questions related to disability....
-
11B-705.1.1.2 Dome size
NOTES 11B-705.1.1.2 Dome size Aligns California Building Code dimensional requirements for detectable warning dome heights with federal ADA...
-
Act
- Source: Definition from ADA Public Law 101- 336...
-
2a
[ADA Stds. 4.21.2] Yes __ No __ N/A __ Comments: ___________________________________________...
-
A6
If a curb ramp is provided, is the running slope of the ramp surface (not counting the side flares) no more than 1:12 or 8.33% [ADA Standards § 4.7.2] Yes No...
-
H17
[ADA Standards § 4.17.4] Yes No...