In bus loading zones restricted to use by designated or specified public transportation vehicles, each bus bay, bus stop, or other area designated for lift or ramp deployment shall comply...
Search Results "Designated Aisle Seat (Assembly)"
-
11B-209.2.2 Bus loading zones
-
Teeing Grounds: ADA Standard Section 238.2.1
Section 238.2.1 covers scoping requirements in the current ADA Standards for teeing grounds.
-
11B-238.2.1 Teeing grounds
Where one teeing ground is provided for a hole, the teeing ground shall be designed and constructed so that a golf car can enter and exit the teeing ground....
-
11B-238.2.1 Teeing grounds
Where one teeing ground is provided for a hole, the teeing ground shall be designed and constructed so that a golf car can enter and exit the teeing ground....
-
Recumbent Bicycles
Two-wheeled recumbents can be difficult to learn to balance, especially those with under-seat steering....
-
26.1 Q. Is a parallel approach required at the shower, as shown in Figure 7(d) of the Guidelines?
For a 36 x 36 shower, as shown in Figure 7(d), a person in a wheelchair would typically add a wall hung seat....
-
A. Measuring Slope and Cross Slope
Surveying ramps, parking spaces, access aisles, door approaches and sidewalks will require you to determine if the slopes (i.e.: in the direction of travel) and cross slopes (i.e....
-
903 Benches
Commenters recommended clarification on the permitted horizontal distance of the back support from the rear edge of the seat....
-
Invisible Wounds: Emerging Promising Practices for Meeting Planners
Advertise the availability of these seats and make sure event staff know about them....
-
§ 36.302(f)(5)(iii)(A) Series-of-events tickets sell-out when no ownership rights are attached
When series-of-events tickets are sold out and a public accommodation releases and sells accessible seating to individuals without disabilities for a series of events, the public accommodation...
-
§ 35.138(e)(3)(i)
When series-of-events tickets are sold out and a public entity releases and sells accessible seating to individuals without disabilities for a series of events, the public entity shall establish...
-
F213.3.1 Toilet Compartments
Full-height partitions and door assemblies can comprise toilet compartments where the minimum required spaces are provided within the compartment....
-
213.3.1 Toilet Compartments
Full-height partitions and door assemblies can comprise toilet compartments where the minimum required spaces are provided within the compartment....
-
5.2.1.1 Transfer Surface Width Recommendations for M301
Edward Steinfeld, Director of the Center of Inclusive Design and Environmental Access at the University of Buffalo, gave a presentation on the Wheeled Mobility Anthropometry Project (AWM...
- Inpro Corporation JointMaster® 103 Series-VCT Expansion Joint Systems
-
4.4 Knee and Toe Clearances
Smaller individuals who have heavy thighs, those with high seats and scooter users also have high lap heights....
-
Grab bars
Two grab bar height options were designed for the study; a 6-inch and a 2.75-inch....
-
Viewing Scopes [1011.2, 1011.3, and 1011.8]
When viewing scopes are provided, separate viewing scopes must be provided for use from a standing position and from a seated position....
- Pilot Rock End Accessible Multi-Pedestal Table APT Series 3"x4" Recycled Plastic
- Lifeguard Above-Ground Spa Lift LSL #100275
-
§382.87(d)
(d) If you have already provided a seat to a passenger with a disability to furnish an accommodation required by this subpart, you must not (except in the circumstance described in §382.85...
-
§ 36.302(f)(8)(ii)
A public accommodation may investigate the potential misuse of accessible seating where there is good cause to believe that such seating has been purchased fraudulently....