5.4.1.1 Transfer Support Location Recommendation for Stretchers For Stretchers, the transfer surface is oriented along the long side of the surface....
Search Results "Curb Ramp Surface"
Commonly Searched Documents
-
5.4.1.1 Transfer Support Location Recommendation for Stretchers
-
4.5.3* CARPET
If carpet or carpet tile is used on a ground or floor surface, then it shall be securely attached; have a firm cushion, pad, or backing or no cushion or pad; and have a level loop, textured...
-
R204.4 Pedestrian Overpasses and Underpasses
Where an overpass, underpass, bridge, or similar structure is designed for pedestrian use only and the approach slope to the structure exceeds 5 percent, a ramp, elevator, limited use/limited...
-
4(5)
(5) Exterior deck, patio, or balcony surfaces are no more than 1/2 inch below the floor level of the interior of the dwelling unit, unless they are constructed of impervious material such...
-
904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
11B-705.1.1.3.2
Detectable warning surfaces shall provide a 70 percent minimum visual contrast with adjacent walking surfaces....
-
§ 38.111(c)
This provision does not require that inaccessible cars be retrofitted with lifts, ramps or other boarding devices....
-
§ 38.21(b)
This provision does not require that inaccessible buses be retrofitted with lifts, ramps or other boarding devices....
-
§ 38.51(b)
This provision does not require that inaccessible vehicles be retrofitted with lifts, ramps or other boarding devices....
-
§ 38.91(b)
This provision does not require that inaccessible cars be retrofitted with lifts, ramps or other boarding devices....
-
§ 38.71(c)
This provision does not require that inaccessible vehicles be retrofitted with lifts, ramps or other boarding devices....
- SciFit Inclusive Fitness PRO2 - Total Body Machine
-
ASME: ADA Standard Section 105.2.2
Section 105.2.2 of the ADA Standards cover references to the American Society of Mechanical Engineers (ASME) standards.
- Detecto 6550 Portable Wheelchair Scale Set-up
-
5.4.1.2 Transfer and Positioning Support Location for Imaging Equipment
Transfer supports should be provided for imaging equipment with transfer surfaces with depths of less than or equal to 24 inches....
-
§ 36.304(c)(1)
These measures include, for example, installing an entrance ramp, widening entrances, and providing accessible parking spaces....
-
Sec.36.304(c)(1)
These measures include, for example, installing an entrance ramp, widening entrances, and providing accessible parking spaces....
-
4.1.7(1)(b)
(b) The Advisory Council shall determine, on a case-by-case basis, whether provisions required by part 4 for accessible routes (exterior and interior), ramps, entrances, toilets, parking...
-
§ 38.159(a)(2) Exception
If portable or station-based lifts, ramps or bridge plates meeting the applicable requirements of this section are provided at stations or other stops required to be accessible under regulations...
-
§ 38.171(b)
This provision does not require that inaccessible vehicles be retrofitted with lifts, ramps or other boarding devices....
-
Edge Protection
Edge Protection Where railings, guards, or handrails are provided, edge protection must be provided and extend a minimum of 2 inches above the ground or deck surface....
-
22. How can I get copies of the ASTM standards that apply to play areas?
American Society for Testing and Materials, 100 Bar Harbor Drive, West Conshohocken, Pennsylvania 19428, www.astm.org: ASTM F 1292-99 Standard Specification for Impact Attenuation of Surface...
-
SEAT HEIGHT MEASUREMENT DETAIL
Note that examination tables and chairs only use bolsters on certain areas of the transfer surface....
-
1.3.2 Focus Following NPRM Comments
This review identified four major issue areas for the MDE Advisory Committee to address, as follows: Transfer surface height and size Permitted obstructions to the transfer surface...