Search Results "Limited Access Space"
Filters
Commonly Searched Documents
-
Figure 703.4.2 Location of Tactile Signs at Doors – Drawing from the U.S. Access Board
-
502.5 Vertical Clearance
Parking spaces for vans and access aisles and vehicular routes serving them shall provide a vertical clearance of 98 inches (2490 mm) minimum. Advisory 502.5 Vertical Clearance....
-
502.5 Vertical Clearance
Parking spaces for vans and access aisles and vehicular routes serving them shall provide a vertical clearance of 98 inches (2490 mm) minimum. Advisory 502.5 Vertical Clearance....
-
11B-207 ACCESSIBLE MEANS OF EGRESS
[See subsections ...]
-
11B-207 Accessible means of egress.
[See subsections ...]
-
11B-207 Accessible means of egress
[See subsections ...]
-
Equipment and furniture.
of temporary or movable structures, such as furniture, equipment, and display racks is not readily achievable to the extent that it results in a significant loss of selling or serving space...
-
SECTION 504 OF THE REHABILITATION ACT OF 1973 POLICY INTERPRETATION NO. 3
The Section 504 regulation was carefully written to require "program accessibility" not "building accessibility," thus allowing recipients flexibility in selecting the means of compliance...
-
7(2)(b)(iii)
(iii) When both tub and shower fixtures are provided in the bathroom, at least one is made accessible....
-
Standards Specific to Assembly Areas
Path of Travel: Wheelchair spaces must be on an accessible route but may not overlap another wheelchair space or the circulation path....
-
221.9 Stadium Style Movie Theaters
Wheelchair spaces and companion seats shall be located on a riser or cross-aisle in the stadium section that satisfies at least one of the following criteria: (i) It is located within the...
-
Gaps
Gaps Where wheelchair spaces are provided on amusement rides, the floors of rides must be coordinated with the floors of the load and unload areas so that when the ride is at the...
-
904.4.1 Parallel Approach
A clear floor or ground space complying with 305 shall be positioned for a parallel approach adjacent to the 36 inch (915 mm) minimum length of counter....
-
2) Where the Standard says "Changes in level are not permitted"
2) Where the Standard says "Changes in level are not permitted", such as 304.2 for turning spaces: Here the standard is followed by an unenforceable advisory that says, "As used in this...
-
City of XXX – ADA Transition Plan
City Hall January 4, 2017 Prepared by: ADA Coordinator and Director of Facilities Area Access Issue Solution Target...
-
604.6 Flush Controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with 604.8.2. Advisory 604.6 Flush Controls....
-
604.6 Flush Controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with 604.8.2. Advisory 604.6 Flush Controls....
-
604.6 Flush Controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with 604.8.2. Advisory 604.6 Flush Controls....
-
Section 1193.39 Prohibited reduction of accessibility, usability and compatibility [1193.29 in the NPRM] (Section-by-Section Analysis)
from both the ADA Accessibility Guidelines (ADAAG) and the Uniform Federal Accessibility Standards (UFAS)....
-
Ticket distribution methods. (Section-by-Section Analysis)
general rule that a public accommodation shall modify its policies, practices, and procedures to ensure that individuals with disabilities can purchase single or multi-event tickets for accessible...
-
Question 10
Is the accessible entrance into the building free of obstacles that block the clear wall and floor space needed for opening the door (between 18 and 42 inches on the latch side of the door...
-
Wheeled Mobility Anthropometry Project
The Wheeled Mobility Anthropometry Project was conducted by the Center for Inclusive Design and Environmental Access....
-
904.4.1 Parallel Approach
A clear floor or ground space complying with 305 shall be positioned for a parallel approach adjacent to the 36 inch (915 mm) minimum length of counter....
