(2) The portion of the residence covered under paragraph (b)(1) of this section extends to those elements used to enter the commercial facility, including the homeowner's front sidewalk,...
Search Results "Enhanced 9-1-1"
-
Sec.36.401(b)(2)
-
106.5.74 Use Zone
ground level area beneath and immediately adjacent to a play structure or play equipment that is designated by ASTM F 1487 (incorporated by reference, see "Referenced Standards" in Chapter 1)...
-
4.5.4 Gratings
If gratings are located in walking surfaces, then they shall have spaces no greater than 1/2 in (13 mm) wide in one direction (see Fig. 8(g))....
-
§100.201a(b)(4) ANSI A117.1-1986
Usability for Physically Handicapped People, 1986 edition, (ANSI A117.1-1986) may be obtained from Global Engineering Documents, 15 Inverness Way East, Englewood, CO 80112, telephone number 1-...
-
FAQ: How do I delete a Voices post?
To delete a Voices post: 1. Login to Corada and click on VOICES. 2. Locate your post and click the title to open it. 3....
-
4.5.4 GRATINGS
If gratings are located in walking surfaces, then they shall have spaces no greater than 1/2 in (13 mm) wide in one direction (see Fig. 8(g))....
-
1193.23(b)(2) (Advisory Guidance)
Paragraph (b)(2) Product Design, Testing, Pilot Demonstrations, and Product Trials 1....
-
Public entity
Public entity means— (1) Any State or local government; (2) Any department, agency, special purpose district, or other instrumentality of a State or States or local government; and...
-
§ 38.95(c)(2) Ramp surface
The ramp or bridge plate surface shall be continuous and slip resistant, shall not have protrusions from the surface greater than 1/4 inch high, shall have a clear width of 30 inches and...
-
§ 38.125(c)(2) Ramp surface
The ramp or bridge plate surface shall be continuous and slip resistant, shall not have protrusions from the surface greater than 1/4 inch high, shall have a clear width of 30 inches and...
-
11B-610.3.1 Rectangular seats
The side edge of the seat shall be 1½ inches (38 mm) maximum from the adjacent wall....
-
11B-809.7.2 Changes in level
Ramps complying with Section 11B-405, elevators complying with Section 11B-407 or platform lifts complying with Section 11B-410 shall be provided where changes in level exceed 1/2 inch (...
-
Safe harbor for qualified small businesses regarding what is readily achievable. (Section-by-Section Analysis)
safe harbor, a qualified small business would have met its readily achievable barrier removal obligations for a given year if, in the preceding tax year, it spent at least one percent (1%...
-
11B-215.2 Public and common use areas
Alarms in public use areas and common use areas shall comply with Chapter 9, Section 907.5.2.3.1. [2010 ADA Standards] 215.2 Public and Common Use Areas....
-
Elevator requirement to new dining area on the mezzanine of an existing facility
Let's assume that this building meets all requirements of 206.2.3 Exception 1 so no elevator is required in the building. ...
-
AJW Architectural Products U6104EA Unidoor Automatic Roll Towel Dispenser & Waste Receptacle Combination - Recessed
Flange: Fabricated of #22 ga stainless steel, satin finish with no miters or welds and 1/4" returns....
-
§382.27(d)
advance notice you require, consistent with this section, for a service that you must provide (see paragraphs (c)(4) through (c)(10) of this section) or choose to provide (see paragraphs (c)(1)...
-
11B-246.2 Camping facilities
two campsites and one additional campsite for each 100 campsites or fraction thereof, shall be accessed by and connected to sanitary facilities by travel routes with a maximum slope of 1:...
-
Table of Contents
Contents 1. Introduction 2. State and Local Government Facilities: Guidance on the Revisions to 28 CFR 35.151 3....
-
Ramps
For each elevated ramp run: 12-inch (305 mm) maximum rise 1:12 maximum slope 36-inch (915 mm) minimum clear width ...
-
409.1 General
unit required to provide mobility features complying with 809.2 through 809.4 shall comply with 409 and with ASME A17.1 (incorporated by reference, see "Referenced Standards" in Chapter 1)...
-
What types of exemptions or exceptions exist?
Compliance with these provisions is not required where EVCS are not available to the general public and intended for use by a designated vehicle or driver (see CBC Section 11B-228.3.2 Exception 1)...
-
409.1 General
unit required to provide mobility features complying with 809.2 through 809.4 shall comply with 409 and with ASME A17.1 (incorporated by reference, see "Referenced Standards" in Chapter 1)...
