Calculate the percentage of the total buildable area of the undisturbed site with a natural grade less than 10-percent slope....
Search Results "Raised Referee Area"
Filters
Commonly Searched Documents
-
TEST NO. 2 – SITE ANALYSIS TEST
-
Reduced scoping for public accommodations, small facilities, and qualified small businesses. (Section-by-Section Analysis)
Department's initial regulatory assessment, the Department has identified ten elements for which the Department believes reduced scoping might be appropriate for barrier removal: play areas...
-
Effect on the certification process of using more than one regulatory scheme at the state or local level to establish accessibility requirements for title III facilities with new design requirements in the proposed standards. (Section-by-Section Analysis)
proposed standards will include requirements for elements and spaces that are not addressed specifically in the 1991 Standards, including elements within recreational facilities and play areas...
-
711.4.1 Through penetrations
Penetrating items with a maximum 6 inch (152 mm) nominal diameter shall not be limited to the penetration of a single fire-resistance-rated floor assembly provided that the area of the penetration...
-
Subpart D -- New Construction and Alterations (Section-By-Section Analysis and Response to Comments)
Potential patrons of places of public accommodation, such as retail establishments, should be able to get to a store, get into the store, and get to the areas where goods are being provided...
-
11B-233.3.1.2.6.3 Test number two, site analysis test
Calculate the percentage of the total buildable area of the undisturbed site with a natural grade less than 10 percent slope....
-
11B-235.2.1 Dispersion
The term "boat slip" is intended to cover any pier area other than launch ramp boarding piers where recreational boats are moored for purposes of berthing, embarking, or disembarking....
-
11B-809.4 Toilet facilities and bathing facilities
Toilet and bathing fixtures required to comply with Sections 11B-603 through 11B-610 shall be located in the same bathroom or toilet and bathing area, such that travel between fixtures does...
-
Section 36.304 Removal of Barriers (Section-By-Section Analysis and Response to Comments)
Whether or not it is necessary to take actions such as ramping a few steps or raising or lowering an ATM would be determined by whether the actions can be accomplished easily and without...
-
ADA25: #17 of 25 -- Recreation
One area we’ve focused on is sports. For example, NFL Football. Watching on TV, we know all that is going on because of the closed captioning. But what about in stadiums?...
-
804.2.2 U-Shaped
In U-shaped kitchens enclosed on three contiguous sides, clearance between all opposing base cabinets, counter tops, appliances, or walls within kitchen work areas shall be 60 inches (1525...
-
1630.2(j)(3)(II)(C)
individual has been disqualified because of an impairment, and the number and types of other jobs not utilizing similar training, knowledge, skills or abilities, within that geographical area...
-
WALK
[DSA-AC] An exterior prepared surface for pedestrian use, including pedestrian areas such as plazas and courts. (As differentiated from the definition of “Sidewalk”.)...
-
802.1.2 Width
Figure 802.1.2 Width of Wheelchair Spaces in Assembly Areas...
-
505.3 Continuity
EXCEPTION: In assembly areas, handrails on ramps shall not be required to be continuous in aisles serving seating....
-
A5. Accessible Parking Spaces
[ADA Stds 4.6.3] If No: Look for a nearby area that is relatively level which could serve as an accessible parking space with an accessible route to the accessible entrance to voting....
-
Head Room [4.4.2]
Otherwise, fixed barriers detectable by canes must define areas with less clearance. Gates, rails, curbs, and other fixed elements, such as planters, can serve as barriers....
-
Special Technical Provisions for Alterations to Existing Buildings and Facilities [4.1.6(3)]
Special provisions also address stairs, elevators, doors, toilet rooms, assembly areas, platform lifts, and dressing rooms....
-
Can handrail extensions wrap or turn?
Extensions are not required for continuous handrails along switchback or dogleg ramps or at aisle ramps serving seating in assembly areas....
-
11B-201.1 Scope
All areas of newly designed and newly constructed buildings and facilities and altered portions of existing buildings and facilities shall comply with these requirements."1 1 "These...
-
11B-608.1 General
Shower stalls that are 60 inches (1525 mm) wide and have no curb may increase the usability of a bathroom because the shower area provides additional maneuvering space....
-
211 Drinking Fountains
Scoping requirements apply where drinking fountains are provided on exterior sites, on floors, and within secured areas....
-
Accessible Restrooms, Fitting Rooms, and Elevators
Maintenance of accessible restrooms and fitting rooms, customer service and product demonstration areas, and lifts and elevators is essential for all customers to fully enjoy the shopping...
-
Teeing Grounds
A rectangular area usually two club-lengths in depth, the teeing ground’s borders are defined by the outside limits of two “tee-markers.”...