In this case, the spring rocker being replaced would need to have the rocker seat height between 11 and 24 inches and clear floor or ground space and maneuvering space provided adjacent...
Search Results "Seat Width"
-
18. Where an existing ground level play component is replaced, should the new component comply with the technical provisions of Section 1008.4 even if there is not an accessible route to it?
-
Receivers and Couplers
Receivers and Couplers ADAAG requires that receivers be provided to serve at least 4% of the total number of seats (but in no case fewer than two)....
-
Motorized Kick Scooters
Motorized scooters usually have hand brakes and often have larger, pneumatic rubber tires; and some have pedestal seats....
-
Listen Technologies ADA Assistive Listening Device Calculator
The calculator allows you to enter the number of seats in a venue to calculate the minimum number of assistive listening devices and neck loops needed to meet new 2010 ADA requirements....
-
Water Closets and Toilet Compartments for Children's Use: ADA Standard Section 604.9
Section 604.9 covers the current ADA Standards for water closets and toilet compartments for children's use.
-
ASME: ADA Standard Section 105.2.2
Section 105.2.2 of the ADA Standards cover references to the American Society of Mechanical Engineers (ASME) standards.
-
Section B: Passenger Drop-Off Area
(§§206.2.1, 503.3) B5 Is the width of the curb ramp surface at least 36” (not counting the side flares)?...
-
406 Curb Ramps
These include specifications for running slope, surface, clear width, and wet conditions. Consistent with the scope of the guidelines, these requirements apply to facilities on sites....
-
PART 3: ACCESSIBLE EXAMINATION ROOMS
The features that make this possible are: an accessible route to and through the room; an entry door with adequate clear width, maneuvering clearance, and accessible hardware;...
-
Protruding Objects [1017.9]
Objects that protrude into the trail clear tread width, passing spaces, and resting intervals can pose hazards to people who are blind or have low vision....
-
11B-504.4.1 Contrasting stripe
The stripe shall extend the full width of the step or upper approach and shall be of material that is at least as slip resistant as the other treads of the stair....
-
Scoping [4.1.2(1), 4.1.3(1)] and Location [4.3.2]
Clear width, surface texture, running and cross slope, and the treatment of changes in level help determine the usability of walking surfaces by people with mobility impairments....
-
Engineered Surfaces
Table 3: Engineered Surface Identification Surface ID: Roughness Index (in/ft): Crack Frequency (in): Crack Width (in):...
-
Clear Floor Space: Minimum Clear Floor Space Required for Forward and Side Approach - Manual Wheelchair
These dimensions are: (A) occupied width, the horizontal distance between the side-most (lateral-most) points of the wheelchair or occupant on the right and left side; (B) occupied length...
-
Clear Floor Space: Minimum Clear Floor Space Required for Forward and Side Approach - Scooter
These dimensions are: (A) occupied width, the horizontal distance between the side-most (lateral-most) points of the wheelchair or occupant on the right and left side; (B) occupied length...
-
Clear Floor Space: Minimum Clear Floor Space Required for Forward and Side Approach - Power Chair
These dimensions are: (A) occupied width, the horizontal distance between the side-most (lateral-most) points of the wheelchair or occupant on the right and left side; (B) occupied length...
-
Is compliance required for parking spaces designed specifically for recreational vehicles such as motor homes and camping or boating trailers?
The ABA Standards address access to RV and other parking spaces at camping and picnic units and pull-up spaces at dump stations and cover space width (minimum 20’, or 16’ in the case of...
-
1.1.5 Flatness of walk running slope
For pedestrian paths up to and including 6 ft (1.8 m) wide, measure for flatness of the running slope at 10 ft (3 m) increments along the midpoint of the width of the walk by using a 10...
-
11B-1007.2 Accessible routes
Where accessible routes intersect playing surfaces of holes, a 1 inch (25 mm) maximum curb shall be permitted for a width of 32 inches (813 mm) minimum....
-
1007.2 Accessible Routes
Where accessible routes intersect playing surfaces of holes, a 1 inch (25 mm) maximum curb shall be permitted for a width of 32 inches (815 mm) minimum. 3....
-
American Standard Times Square Deck- Mount Bathtub Faucet with Personal Shower
Specs Dimensions Height - 11-1/4" Width - 6-1/2" - 12"...
-
Salsbury Industries Custom Designer Lockers 30000C
Ranging from one to seven (7) tiers, custom designer lockers can be ordered in any combination of five (5) heights (36", 48", 60", 72" and 84"), five (5) widths (12", 15", 18", 21" and 24...
-
AJW Architectural Products UJ14 Series UJ14A Hook Strip 26"L, 3 Hooks - Surface Mounted
Product Features Fabricated of #18 gauge stainless steel with #4 satin finish Units with greater widths require additional hooks Custom lengths available Product Specs Hook...
-
216 and 703 Signs
These types of signs include: seat and row designations in assembly areas; occupant names, building addresses; company names and logos; signs in parking facilities (except those identifying...
