b) Should diagnostic equipment used by patients in a seated position that provide stirrups such as urodynamics study chairs be required to provide a method of supporting, positioning, and...
Search Results "Seat Height"
Filters
Commonly Searched Documents
-
Stirrups (M301.3.2)
-
Grab Bar and Backrest Evaluation
The analysis also revealed that the presence of grab bars helped participants to transfer higher and lower than their mobility device seats....
-
Equivalent Facilitation [§103]
For example, transfer shower stalls are required to be 36 inches by 36 inches absolute so that grab bars remain within reach from the seat....
-
Section G: Ramps
(§405.3) G3 Is the rise (height) for any ramp run 30" or less?...
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
When toilet and bathing facilities have doorway openings instead of doors, such as at airports or stadiums, the geometric identification symbol should be located at the proper height adjacent...
-
604.5 Grab Bars
must be sufficient to permit the installation of rear and side wall grab bars that fully meet all accessibility requirements including, but not limited to, required length, installation height...
-
604.5 Grab Bars
must be sufficient to permit the installation of rear and side wall grab bars that fully meet all accessibility requirements including, but not limited to, required length, installation height...
-
QUESTION: WHAT CONSTITUTES AN ALTERATION TO A PLATFORM FOR PURPOSES OF TRIGGERING THE APPLICATION OF SECTION 37.42 REQUIREMENTS?
For example, if the platform height relative to the top of rail is raised, if the old surface is removed and/or a new surface put down, or if there is a reconstruction of or structural change...
-
E. Chapter 4: Boarding and Alighting
the technical requirements for the slope of ramps in non-rail vehicles by specifying a single standard (1:6) for maximum running slope applicable to ramps deployed to roadways or curb-height...
-
Interior Routes
INTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Carpet pile height 1/2 inch...
-
4.1.3(17)(a)
At least one public telephone per floor shall meet the requirements for a forward reach telephone3. 1 Additional public telephones may be installed at any height....
-
Interior Routes
INTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Carpet pile height 1/2 inch...
-
2.2 Key Measurement Variables and Procedures
Reaches and lifts: One-handed maximum reaches recorded at 5 different heights in three different directions for up to four different weight conditions (maximum of 60 reaches total). 4...
-
Guidelines
Tactile objects are tied closely to the exhibit’s interpretive theme and defy the same standardized approach that can be applied to an exhibit’s mounting height, door size and location,...
-
11B-405.5 Clear width
Handrails may project into the required clear width of the ramp at each side 3½ inches (89 mm) maximum at the handrail height. 3....
-
11B-607.4 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped or U-shaped grab bar meeting the dimensional requirements of Section 11B-607.4.1 or 11B-607.4.2...
-
11B-405.5 Clear width
Handrails may project into the required clear width of the ramp at each side 3½ inches (89 mm) maximum at the handrail height....
-
11B-607.4 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped or U-shaped grab bar meeting the dimensional requirements of Section 11B-607.4.1 or 11B-607.4.2...
-
TotTurf® Synthetic Grass: Play Spaces
Real grass look keeps parks and playgrounds visually serene and environmentally pleasing Available in varying heights and colors to fulfill specific play area needs (see table below...
-
ADA Sign Products Exit Sign (6" x 3")
Exit Sign (6"x3") Part Number 103.01.02 Width = 6" Height = 3" Material = 1/8" thermo formed acrylic...
-
Kompan, Inc. ELE400021 - Blazer Spring Toy
This multi-user spring toy accommodates up to three children on the seats while a few more can pile onto the center platform....
-
Inclusion Solutions Voter Entrance Sign
Sign Height: 14" Portable, lightweight signs can solve parking and other Election Day accessibility issues...
-
11B-502.3.3 Marking
The words "NO PARKING" shall be painted on the surface within each access aisle in white letters a minimum of 12 inches (305 mm) in height and located to be visible from the adjacent vehicular...
