ANSWER: The performance standard and other requirements of section 37.42(a) apply to stations that are approved for entry into final design or that begin construction or alteration...
Search Results "Floor Designation"
Filters
Commonly Searched Documents
-
QUESTION: WHEN DO THE REQUIREMENTS OF SECTION 37.42 BEGIN TO APPLY?
-
Feminine product dispensers
For purposes of resolving this matter, the Museum will provide, on each floor, at least one feminine product dispenser in the women's toilet rooms that does not requires tight grasping and...
-
803.5 Coat Hooks and Shelves
Shelves shall be 40 inches (1015 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
-
1i
Are all of the small showers free of curbs or lips greater than 1/2" high at the shower floor that would impede wheelchair approach and transfer onto the folding shower seat?...
-
Volume Controls
Do at least 25% (not less than one) of all other house phones on each floor have volume controls? Yes __ No __ N/A __ Comments: ___________________________________________...
-
Volume Controls
Do at least 25% (not less than one) of all other pay phones on each floor have volume controls? Yes __ No __ N/A __ Comments: ___________________________________________...
-
Volume Controls
Do at least 25% (not less than one) of all other pay phones on each floor have volume controls? Yes __ No __ N/A __ Comments: ___________________________________________...
-
§ 38.31(b)
doorways in which lifts or ramps are installed, shall have, at all times, at least 2 foot-candles of illumination measured on the step tread, or lift or ramp, when deployed at the vehicle floor...
-
11B-809.8.4 Door signal devices
The activating mechanism shall be mounted 48 inches (1219 mm) maximum above the floor and connected to permanent wiring....
-
308 Reach Ranges
Comments from the elevator industry noted that a 48 inch maximum height would adversely impact the design of elevator controls....
-
C.
Pursuant to Title III of the ADA, all places of public accommodation – including Cinemark's stadium-style movie theaters – that were designed and constructed for first occupancy after January...
-
L.
Cinemark's stadium-style movie theater designs in Texas were approved by the Texas Department of Licensing and Regulation as accessible under the Texas Accessibility Standards, state accessibility...
-
Equivalent Facilitation
Equivalent Facilitation Designs, products, or technologies can be used as alternatives to those prescribed, provided they result in substantially equivalent or greater accessibility or...
-
Executive Order 12611, Federalism
The General Counsel, as the Designated Official under section 6(a) of Executive Order No. 12611, Federalism, has determined that this notice does not involve the preemption of State law...
-
12148(a)(1) In general
(1) In general With respect to existing facilities used in the provision of designated public transportation services, it shall be considered discrimination, for purposes of section 12132...
-
APPENDIX
This appendix contains additional information that should help the designer to understand the minimum requirements of the standard or to design buildings or facilities for greater accessibility...
-
1118B.3
SECTION 1124B - GROUND AND FLOOR SURFACES 1124B.1 General. ...
-
4.1.1 Range of Examination Table and Chair Configurations
These demands have implications for the design, configuration, and principles of operation of examination tables and chairs....
-
Medical Device Manufacturers
The size of the economic incentive will depend on the amount of accessible medical diagnostic equipment health care providers need to acquire and the manufacturers’ incremental costs to design...
-
2.5.2.2 International Organization for Standardization (ISO) Standards
2.5.2.2 International Organization for Standardization (ISO) Standards The primary standard from ISO used in the design of medical devices is ISO 14971, “Medical devices - Application...
-
Introduction
The following booklet is designed to be a tool kit that will provide guidance and resources for professionals in the hospitality industry. ...
-
National Accessibility Code
In furtherance of this objective, the Department has relied upon the ANSI Standard as the design basis for the Fair Housing Accessibility Guidelines....
-
SECTION 406 MOTOR-VEHICLE-RELATED OCCUPANCIES
406.2 Design. …...
-
306.3.4 Clearance Reduction
Between 9 inches (230 mm) and 27 inches (685 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...