colors and captured on four sides by integral, extruded reglets Life time warranty door corner construction consist of mitered corners with angle alignment blocks secured with 3/8" full-width...
Search Results "Seat Width"
-
Kawneer North America Flushline™ Entrances
-
216 and 703 Signs
These types of signs include: seat and row designations in assembly areas; occupant names, building addresses; company names and logos; signs in parking facilities (except those identifying...
-
11B-209.4 Valet parking
Some vehicles may be adapted with hand controls or lack a driver’s seat, and may not be operable by a valet parking attendant....
-
Technical Memorandum TM 2013-11 Benches
Steam Rooms TAS 612.2 Dressing, Fitting, and Locker Rooms TAS 803.4 Holding Cells and Housing Cells TAS 807.2.2 Fixed or built-in benches and other types of fixed seating...
-
H29
Accessible Shower Stall Minimum Size and Clearances Accessible Shower Stall Grab Bars and Seat, Shower, and Control Area...
-
Access to Performing Areas [4.33.5]
While handrails are not required on ramps adjacent to assembly seating, locating aisles (including those that are stepped) along walls will permit handrails on one side for the benefit of...
-
Error/Omission: When a transfer shower is used, it is often larger than the required 36" x 36" size.
Users may slide off the seat and fall onto the floor of the shower while reaching for the shower controls and hand-held showerhead. Requirement: 4.21.2 Size and Clearances....
-
1009.3.3 Area of Refuge
Areas of refuge are not required for smoke-protected or open-air assembly seating areas complying with Sections 1029.6.2 and 1029.6.3....
-
Issues Related to the Interactive Process and Return to Work
The employer asks if the employee could do seated work during the break; the doctor says yes....
-
B.2.ii. - How should an agency proceed in identifying "applicable" technical provisions in Subparts B, C, and D of the Access Board’s standards to ensure acquired products provide comparable access?
For example, if an agency were to enter into a seat management contract for desktop computing resources, the hardware and software to be provided by the contractor would be required to meet...
-
Alternative Designs
The tub has a non-institutional appearance, a fold-down seat, and a swinging side entry door with a pressurized seal for ease of access....
-
Storing Assistive Devices in the Aircraft Cabin
[Sec. 382.41(b)] You must permit passengers to stow their canes and other assistive devices in the cabin and close to their seats, consistent with FAA safety regulations concerning carry-on...
-
1007.2 Accessible Routes
Where accessible routes intersect playing surfaces of holes, a 1 inch (25 mm) maximum curb shall be permitted for a width of 32 inches (815 mm) minimum. 3....
-
Section B: Passenger Drop-Off Area
(§§206.2.1, 503.3) B5 Is the width of the curb ramp surface at least 36” (not counting the side flares)?...
-
406 Curb Ramps
These include specifications for running slope, surface, clear width, and wet conditions. Consistent with the scope of the guidelines, these requirements apply to facilities on sites....
-
PART 3: ACCESSIBLE EXAMINATION ROOMS
The features that make this possible are: an accessible route to and through the room; an entry door with adequate clear width, maneuvering clearance, and accessible hardware;...
-
Protruding Objects [1017.9]
Objects that protrude into the trail clear tread width, passing spaces, and resting intervals can pose hazards to people who are blind or have low vision....
-
11B-504.4.1 Contrasting stripe
The stripe shall extend the full width of the step or upper approach and shall be of material that is at least as slip resistant as the other treads of the stair....
-
Scoping [4.1.2(1), 4.1.3(1)] and Location [4.3.2]
Clear width, surface texture, running and cross slope, and the treatment of changes in level help determine the usability of walking surfaces by people with mobility impairments....
-
Engineered Surfaces
Table 3: Engineered Surface Identification Surface ID: Roughness Index (in/ft): Crack Frequency (in): Crack Width (in):...
-
Clear Floor Space: Minimum Clear Floor Space Required for Forward and Side Approach - Manual Wheelchair
These dimensions are: (A) occupied width, the horizontal distance between the side-most (lateral-most) points of the wheelchair or occupant on the right and left side; (B) occupied length...
-
Clear Floor Space: Minimum Clear Floor Space Required for Forward and Side Approach - Scooter
These dimensions are: (A) occupied width, the horizontal distance between the side-most (lateral-most) points of the wheelchair or occupant on the right and left side; (B) occupied length...
-
Clear Floor Space: Minimum Clear Floor Space Required for Forward and Side Approach - Power Chair
These dimensions are: (A) occupied width, the horizontal distance between the side-most (lateral-most) points of the wheelchair or occupant on the right and left side; (B) occupied length...
-
Is compliance required for parking spaces designed specifically for recreational vehicles such as motor homes and camping or boating trailers?
The ABA Standards address access to RV and other parking spaces at camping and picnic units and pull-up spaces at dump stations and cover space width (minimum 20’, or 16’ in the case of...