Gates which must be pushed open by wheelchair or mobility aid users shall have a smooth continuous surface extending from 2 inches above the floor to 27 inches above the floor and shall...
Search Results "Floor Destination"
-
220 Automatic Teller Machines and Fare Machines
-
Alternative Designs
In addition, the fixture is also taller than most average bathtubs (24" above the finished floor) which permits immersion in the water even when using its fold-down seat....
-
11B-805.7 Built-in cabinets and work surfaces
A 30-inch by 48-inch clear floor space, in compliance with Section 11B-305, shall be centered in front of the display screen....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
II-5.1000 General
Civil suits are routinely heard in a courtroom on the second floor of the courthouse. The courthouse has no elevator or other means of access to the second floor....
-
1. Costs: Summary of Methodology and Results
The other four requirements—signage for accessible seating and doorways, exterior destination or route signs, public address systems, and stop request systems—while applicable to non-rail...
-
Category 3 Eligibility
A wheelchair user can often get around this problem by taking a less direct route to a destination than an ambulatory person would take....
- Access-Able Designs Child Dressing Bench CH-101
- SDC Bollard Post with Push Plate or Touch Panel
- Hoyer Presence Heavy-Duty Lift
- ASI Global Partitions High Density Polyethylene Solid Plastic Toilet Partitions
- Cybex Total Access Leg Extension Exercise Machine
- Allegion Von Duprin 94/95 Series INPACT Recessed Exit Device
-
11B-216.2 Designations
Examples include interior signs labeling restrooms, room and floor numbers or letters, and room names....
-
11B-216.2 Designations
Examples include interior signs labeling restrooms, room and floor numbers or letters, and room names....
-
11B-226.1 General
requirements of Section 226.1 and 902 of the 2010 ADA Standards, which are identical to the requirements in the CBC Chapter 11B Section 11B-226.1 and 11B-902, including providing clear floor...
-
F216.2 Designations
Examples include interior signs labeling restrooms, room and floor numbers or letters, and room names....
-
704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (865 mm) minimum above the finish floor....
-
Detectable Warnings
This revision does not substantively change the requirements for the coordination of platforms and vehicle floors. 28 36 CFR part 1192...
-
Companion Seats
Consistent with the ANSI A117.1‒2003 standard, the provision in the final rule specifies that shoulder alignment is to be measured 36 inches from the front of the wheelchair space and that the floor...
-
1007.6.1 Size
Exception: The enforcing agency may reduce the size of each required area of refuge to accommodate one wheelchair space that is not less than 30 inches by 48 inches (762 mm by 1219 mm) on floors...
-
1007.7.4 Separation
The fire-resistance-rated construction shall extend vertically from the ground to a point 10 feet (3048 mm) above the floor level of the area for assisted rescue or to the roof line, whichever...
-
Is it OK to examine a patient who uses a wheelchair in the wheelchair, because the patient cannot get onto the exam table independently?
A good option is to have a table that adjusts down to the level of a wheelchair, approximately 17‒19 inches from the floor....
-
Water Closet Location and Rear Grab Bar
., when a lavatory or other recessed fixture is located next to the water closet and the wall behind the lavatory is recessed so that the lavatory does not overlap the required clear floor...