Rail platforms shall not exceed a slope of 1:48 in all directions....
Search Results "9-1-1 Service"
Filters
Commonly Searched Documents
-
11B-810.5.1 Slope
-
11B-206.2.3.1 Stairs and escalators in existing buildings
modifications are necessary for the installation, an accessible route shall be provided between the levels served by the escalator or stair unless exempted by Section 11B-206.2.3 Exceptions 1...
-
11B-404.2.4.4 Floor or ground surface
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted. Exceptions: Reserved....
-
F217.2 Wheelchair Accessible Telephones
Wheelchair Accessible Telephones Number of Telephones Provided on a Floor, Level, or Exterior Site Minimum Number of Required Wheelchair Accessible Telephones 1...
-
217.2 Wheelchair Accessible Telephones
Number of Telephones Provided on a Floor, Level, or Exterior Site Minimum Number of Required Wheelchair Accessible Telephones 1...
-
17. May an employer apply a "no-fault" leave policy, under which employees are automatically terminated after they have been on leave for a certain period of time, to an employee with a disability who needs leave beyond the set period?
additional unpaid leave as a reasonable accommodation, the employer must modify its "no-fault" leave policy to provide the employee with the additional leave, unless it can show that: (1)...
-
Paragraph (b) (Advisory Guidance)
Paragraph (b) Connection Point for External Audio Processing Devices 1....
-
Mockett DH403-BB Square Bar Door Handle Back to Back
Leather bound handles with 1” square body make for an easy grip surface. Classic look in a stunningly modern design. Sold as a set of 2. Back to back mounting hardware included....
-
H. Repairing and Rebuilding
local governments often make alterations to facilities to repair such damage, construct facilities to replace those that were destroyed or extensively damaged, or move government programs, services...
-
Thresholds [§404.2.5]
Thresholds [§404.2.5] The height of thresholds is limited to 1/2” in new construction. The edge must be beveled 1:2 maximum above a height of 1/4”....
-
11B-809.10.6.5 Thresholds
Where provided thresholds shall be 2 inches (51 mm) maximum in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units horizontal (26.6 degrees from the horizontal...
-
C1-4. Accessible Route Level Changes
Is the accessible route free of steps and abrupt level changes over 1/2 inch? Note: Level changes between 1/4 inch and 1/2 inch should be beveled. Yes _____ No _____...
-
1193.23(b)(3) (Advisory Guidance)
Paragraph (b)(3) Working Cooperatively with Appropriate Disability-Related Organizations 1....
-
219.3 Receivers
EXCEPTIONS: 1....
-
SmartCells Flooring: Anti-Fatigue Matting
SATECHinc.com/media Ergonomic research shows that the best anti fatigue matting provides a balance of 9 key elements....
-
Ensure that people with mental health disabilities or I/DD have an equal opportunity to participate in and benefit from the entities’ programs, services, and activities
Ensure that people with mental health disabilities or I/DD have an equal opportunity to participate in and benefit from the entities’ programs, services, and activities....
-
A. Access Board
The Access Board is an independent federal agency established by Section 502 of the Rehabilitation Act (29 U.S.C. 792).1 The Access Board is responsible for developing accessibility guidelines...
-
Changes in Level [§303]
Changes in Level [§303] Changes in level can be up to ¼” without treatment or ½” if beveled with a slope no steeper than 1:2....
-
Assisted Living Directory - Connecticut Assisted Living Facilities & Senior Care
The State of Connecticut defines assisted living as ‘a special combination of housing, supportive services, personalized assistance and health care designed to respond to the individual...
-
Running Slope [1018.7.1]
The running slope of any segment of a beach access route must be no steeper than 1:10 (10 percent)....
-
505.6 Gripping Surface
Where provided, horizontal projections shall occur 1 1/2 inches (38 mm) minimum below the bottom of the handrail gripping surface. EXCEPTIONS: 1....
-
Department of Justice method
For a 1:50 slope this is 1/2 inch; for a 1:20 slope it is approximately 1 - 1/4 inch and for a 1:12 slope it is 2 inches."...
