Respondents reported the following types of design alternatives: Water Closet: The water closet was moved further away from the sidewall (> 18+" from the sidewall to the centerline...
Search Results "Vanity Centerline"
-
Types of Alternative Designs
-
11B-805.7 Built-in cabinets and work surfaces
Touch screen units shall be allowed to be vertically mounted with the centerline of the display screen no more than 52 inches above the floor in compliance with Section 11B-707.7.1.1....
-
Attachment I
The toilet is inaccessible because the centerline is 16 inches from the side wall and the seat is 16 ½ inches above the finished floor. ...
-
Opening Force [§404.2.9]
so that the face edge aligns with the door frame outside edge Place gauge immediately above door operating hardware about 2½” from the latch edge of the door (approximately the centerline...
-
11B-805.7 Built-in cabinets and work surfaces
Touch screen units shall be allowed to be vertically mounted with the centerline of the display screen no more than 52 inches above the floor in compliance with Section 11B-707.7.1.1....
-
11B-604.3.2 Overlap
Exception: In residential dwelling units, a lavatory complying with Section 11B-606 shall be permitted on the rear wall 18 inches (457 mm) minimum from the water closet centerline where...
-
11B-604.3.2 Overlap
Exception: In residential dwelling units, a lavatory complying with Section 11B-606 shall be permitted on the rear wall 26 inches (660 mm) minimum from the water closet centerline to allow...
-
Guidelines for Requirement 7
specifications also provides that toilets must be located in a manner that permits a grab bar to be installed on one side of the fixture, and provides specifications on the installation of vanities...
-
11B-404.2.9 Door and gate opening force
At each location where push plates are provided there shall be two push plates; the centerline of one push plate shall be 7 inches (178 mm) minimum and 8 inches (203 mm) maximum above the...
-
11B-404.2.9 Door and gate opening force
At each location where push plates are provided there shall be two push plates; the centerline of one push plate shall be 7 inches (178 mm) minimum and 8 inches (203 mm) maximum above the...
-
11B-404.2.9 Door and gate opening force
At each location where push plates are provided there shall be two push plates; the centerline of one push plate shall be 7 inches (178 mm) minimum and 8 inches (203 mm) maximum above the...
-
Fur out the wall
The centerline of the water closet shall be 16 inches (405 mm) minimum to 18 inches (455 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (430...
-
Eliason Corporation SCP-8 High Pressure Laminate Traffic Door
" thick decorative high pressure laminate (both sides) Hinge: Eliason Easy Swing® Hinge System Window: Standard 9" x 14" clear acrylic set in black rubber molding at 60" AFF to the centerline...
-
TownSteel ED1300 Grade 1 Concealed Vertical Rod Panic Device
up to 8' wide x 10' high opening Dogging Flat Key standard, Cylinder Dogging and Less Dogging optional Fasteners For 1-3/4" - 2-1/4" thick wood and metal door applications Device centerline...
-
A4.22.3 Clear Floor Space
To accommodate the side transfer, the space adjacent to the water closet must remain clear of obstruction for 42 in (1065 mm) from the centerline of the toilet (Figure 28) and the lavatory...
-
Restoring Your Natural Radiance Through Biological Aesthetics
It is not vanity; it is a desire for your external appearance to match your internal vitality....
-
Water Closet Clear Floor Space in Toilet Compartments
However, in residential dwelling units, an accessible lavatory adjacent to water closets can overlap this space (18 inches minimum from the water closet centerline) if additional space is...
-
Allegion Von Duprin 33A/35A Series Exit Devices
|4" (57mm) Wood & Metal Doors; #425 SNB furnished standard for end case; #325 SNB furnished standard for EO (exit only device) Latch Bolt: Deadlocking, 3/4" (19mm) throw Device Centerline...
-
Toilet Buildings and Pit Toilets
Of the required width of clear floor space, ensure that only 16 to 18 inches (405 to 455 millimeters) is on one side of the centerline of the riser; the rest must be on the other side....
-
Flush Controls on Toilets
If it's a centered button that has some diameter that provides a portion of the button on the wide side of the centerline, there's an argument that says that is on the open side because...
-
Alterations and water closet clearances in single-user toilet rooms with in-swinging doors. (Section-by-Section Analysis)
The 1991 Standards allow a lavatory to be placed a minimum of 18 inches from the water closet centerline and a minimum of 36 inches from the side wall adjacent to the water closet, which...
-
ETA Opinion: ADA Signage at Exit Doors
needing correction: Where exit signs are provided, there are no exit signs with Braille and raised letters mounted on the wall on the latch side of the door at 60" above the floor to the centerline...
-
Alterations and Water Closet Clearances in Single-User Toilet Rooms With In-Swinging Doors (Section-by-Section Analysis)
Clearances in Single-User Toilet Rooms With In-Swinging Doors (Section-by-Section Analysis) The 1991 Standards allow a lavatory to be placed a minimum of 18 inches from the water closet centerline...
-
M301.4.1 Clearance in Base (Section-by-Section Analysis)
Additionally, the Access Board proposed to permit equipment components to be located within 8 inches maximum of the centerline of the clearance width. Id....
