Where boarding piers are provided at boat launch ramps, at least 5 percent, but no fewer than one, of the boarding piers shall comply with Section 11B-1003.3.2....
Search Results "Modular Ramp"
Commonly Searched Documents
-
11B-235.3 Boarding piers at boat launch ramps
-
11B-405.7.2.1
Where the ramp width is less than the top landing width additional landing length may be necessary to accommodate handrail extensions required to be in the direction of the ramp run without...
-
Running Slope of Ramps Deployed to Roadways or Curb-Height Bus Stops
1:4) ramp models, and were already in service on thousands of ramp-equipped low floor buses....
-
11B-406.5.2 Width
The clear width of curb ramp runs (excluding any flared sides), blended transitions, and turning spaces shall be 48 inches (1219 mm) minimum....
-
4.8.5* Handrails
If a ramp run has a rise greater than 6 in (150 mm) or a horizontal projection greater than 72 in (1830 mm), then it shall have handrails on both sides....
-
106.5.13 Boat Launch Ramp
A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water.
-
11B-505.10.1 Top and bottom extension at ramps
Ramp handrails shall extend horizontally above the landing for 12 inches (305 mm) minimum beyond the top and bottom of ramp runs....
-
11B-505.10.1 Top and bottom extension at ramps
Ramp handrails shall extend horizontally above the landing for 12 inches (305 mm) minimum beyond the top and bottom of ramp runs....
-
11B-505.1 General
Handrails provided along walking surfaces complying with Section 11B-403, required at ramps complying with Section 11B-405, and required at stairs complying with Section 11B-504 shall comply...
-
405.4 Floor or Ground Surfaces
Floor or ground surfaces of ramp runs shall comply with 302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
405.4 Floor or Ground Surfaces
Floor or ground surfaces of ramp runs shall comply with 302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
§35.151(e)
(e) Curb ramps....
-
405.1 General
Ramps on accessible routes shall comply with 405....
-
405.1 General
Ramps on accessible routes shall comply with 405....
-
Clear Width [§405.5]
Clear Width [§405.5] Ramp runs must have a clear width of 36” minimum (measured between handrails where provided)....
- Safepath EZ Edge™ Transition
-
405.4 Floor or Ground Surfaces
Floor or ground surfaces of ramp runs shall comply with 302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
405.1 General
Ramps on accessible routes shall comply with 405....
-
11B-405.1 General
Ramps on accessible routes shall comply with Section 11B-405....
-
11B-405.1 General
Ramps on accessible routes shall comply with Section 11B-405....
-
11B-405.1 General
Ramps on accessible routes shall comply with Section 11B-405....
-
4.1.6(4)(a)
(a) Ramps....
-
4.8.3 Clear Width
The minimum clear width of a ramp shall be 36 in (915 mm)....
-
4.8.4(1)
(1) The landing shall be at least as wide as the ramp run leading to it....