A turning space complying with Sections 11B-304.2 and 11B-304.3 shall be provided in load and unload areas....
Search Results "Bus Boarding Area"
Commonly Searched Documents
- 
    
  
  11B-1002.3 Load and unload areas
  
- 
    
  
  A. Door Width
  Achieving a 30 inch wide front door on an over-the-road bus is considered not feasible if doing so would necessitate reduction of the bus approach angle, relocating the front axle rearward... 
- 
    
  
  § 38.171(c)
  Architectural and Transportation Barriers Compliance Board (Access Board).... 
- 
    
  
  Introduction
  Introduction The Access Board is an independent federal agency established by section 502 of the Rehabilitation Act (29 U.S.C. 792).1 The Access Board is responsible for developing accessibility... 
- 
    
  
  R308.1.2.2 Slope
  Boarding platforms shall not exceed a slope of 2 percent in any direction.... 
- 
    
  
  Assembly Areas [4.33]
  Assembly Areas [4.33] ADAAG requirements for assembly areas apply to areas where groups of people gather for recreational, educational, political, social, or amusement purposes or for... 
- 
    
  
  IV.B.1.
  Where destination or route information is displayed on the exterior of a vehicle, each vehicle shall have illuminated signs on the front and boarding side of the vehicle.... 
- BraunAbility NL500 Series and NUVL855 Wheelchair Lift for 24 Volt Motorcoaches
- BraunAbility Century 2 Wheelchair Lift for School Buses, Cutaway Buses, and Paratransit Vans
- BraunAbility Vista 2 Wheelchair Lift for School Buses, Cutaway Buses, and Paratransit Vans
- BraunAbility Millenium 2 Wheelchair Lift for School Buses, Cutaway Buses, and Paratransit Vans
- BraunAbility UVL Wheelchair Lift for Cutaway Buses and Paratransit Vans
- 
    
  
  12186(c) Consistency with ATBCB guidelines
  issued under subsections (a) and (b) of this section shall be consistent with the minimum guidelines and requirements issued by the Architectural and Transportation Barriers Compliance Board... 
- 
    
  
  § 38.23(c)(5) Slope
  (5) Slope. Ramps shall have the least slope practicable and shall not exceed 1:4 when deployed to ground level. If the height of the vehicle floor from which the ramp is deployed is... 
- 
    
  
  § 38.23(c)(6) Attachment
  When in use for boarding or alighting, the ramp shall be firmly attached to the vehicle so that it is not subject to displacement when loading or unloading a heavy power mobility aid and... 
- 
    
  
  § 38.83(a)(1) General
  All new light rail vehicles, other than level entry vehicles, covered by this subpart shall provide a level-change mechanism or boarding device (e.g., lift, ramp or bridge plate) complying... 
- 
    
  
  240 Play Areas
  240 Play Areas... 
- 
    
  
  1008 Play Areas
  1008 Play Areas... 
- 
    
  
  T402 Ramps and Bridgeplates
  [See subsections ...] 
- 
    
  
  12182(b)(2)(D) Over-the-road buses
  (D) Over-the-road buses 
- 
    
  
  Sec. 12145. Temporary relief where lifts are unavailable. [Section 225]
  [See subsections ...] 
- 
    
  
  § 37.187 Interline service
  [See subsections ...] 
- 
    
  
  § 38.23(b)(2)(i) Requirements
  (i) Requirements. The controls shall be interlocked with the vehicle brakes, transmission, or door, or shall provide other appropriate mechanisms or systems, to ensure that the... 
- 
    
  
  § 38.31 Lighting
  [56 FR 45756, Sept. 6, 1991, as amended at 63 FR 51697, 51702, Sept. 28, 1998] 
