Facilities F203 General Exceptions F204 Protruding Objects F205 Operable Parts F206 Accessible Routes F207 Accessible Means of Egress F208 Parking...
Search Results "Parking Space Length"
Commonly Searched Documents
-
Table of Contents
-
Counters and Bars [5.2]
Types of Counters Maximum Height Minimum Length Knee Clearance (forward approach) Dining/Bars (service) 34 in 60 in required Dining/Bars...
-
PATH OF TRAVEL
or facility by means of which a particular area may be approached, entered and exited, and which connects a particular area with an exterior approach (including sidewalks, streets, and parking...
-
Selection of Variables
Selection of Variables Our own review of the ADAAG requirements, plus that of our subcontractor KRW, reveals that the single most needed anthropometric datum, by far, is arm length....
-
T402.5 Surfaces
Ramp and bridgeplate surface material shall comply with T302 and extend across the full width and length of the ramp or bridgeplate....
-
1133A.4, Item 1
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for the kitchen sink installation....
-
1017.7 Slopes
This section contains technical requirements for the maximum running slope and segment length (1017.7.1) and cross slope (1017.7.2) of trails....
-
1133A.4, Item 1
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for the kitchen sink installation....
-
BUILDING
Parking lots, play areas, patios, constructed trails, man-made outdoor areas are often not considered to be buildings. Rather, these elements are generally considered to be facilities....
- Hoyer Journey Stand-Up Lift
- Hoyer Ascend Stand-Up Lift
-
C) Accessible Entrance
The accessible route must connect one or more (exterior) site entry points (such as parking, a public sidewalk, or a public transportation stop) with an accessible entrance....
-
Side Transfer Surface
A transfer surface located within the length of the examination surface that allows patient transfer on two opposing sides of the examination surface....
-
M305.2.1.1 End Transfer Supports
Transfer supports for transfer surfaces complying with M301.2.3.1 and M302.2 shall be located on the short side (length) opposite the transfer side....
-
6.8.1 Size
The resting interval length shall be a minimum of 60 inches (1525 mm) long by 60 inches (1525 mm) wide....
-
505.6 Gripping Surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
11B-505.6 Gripping surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
11B-406.5.3 Landings
The landing clear length shall be 48 inches (1219 mm) minimum....
- Kompan, Inc. Electronic Playgrounds ICON1012 Space Video
-
1018.7 Slopes
This section contains technical requirements for the maximum running slope and segment length (1018.7.1) and cross slope (1018.7.2) of beach access routes....
-
Boarding Piers at Boat Launch Ramps: ADA Standard Section 1003.2.2
Where the total length of the gangway or series of gangways serving as part of a required accessible route is 30 feet (9145 mm) minimum, gangways shall not be required to comply with 405.2...
-
New construction and alteration requirements
Alterations to facilities, spaces or elements (including renovations) on or after January 26, 1992, also must comply with the Standards....
-
Accessible Round Table Style
Aisles between round tables require at least three feet of space between the tables (measured from the back of one chair to the back of the chair directly behind it)....
-
4.1.6(3)(d)
EXCEPTION: If the cost of the elements and spaces required by 4.1.6(3)(a), (b), or (c) exceeds 15 percent of the total cost of all other alterations, then a schedule may be established by...