Exceptions: Penetrations by steel, ferrous or copper conduits, pipes, tubes, vents, concrete, or masonry through a single fire-resistance-rated floor assembly where the annular...
Search Results "NFSI: National Floor Safety Institute"
-
711.4.1 Through penetrations
-
308 Reach Ranges
Gas pumps are often located on curbs at least 6 inches high for safety reasons....
-
g-iii
Is there clear maneuvering floor space in front of each accessible door (see ADA Standards § Fig. 25) and, on the pull side, is there at least 18 inches clear floor space beyond the latch...
-
E2-2. Overhead Objects
Are pedestrian routes leading to or serving the voting area free of overhead objects with the bottom edge lower than 80 inches above the floor?...
-
11B-813.2.1.3 Height and operation
Adult changing table height shall be adjustable from 17 inches (432 mm) above the floor or ground to 38 inches (965 mm) above the floor or ground, as measured to the top of the changing...
- Adaptive Access
-
General
The changes in the 2010 Standards are expected to have minimal impact since the model fire and life safety codes, which are adopted by all of the states, contain equivalent requirements...
-
Doors in a Series
finalizing this rule and incorporating its guidelines for recreation facilities, the Board determined that the specified height for door and gate hardware conflicts with industry practice or safety...
-
Comments
Some commenters mentioned safety and potential damage to vehicles and equipment as concerns if larger or more irregularly shaped wheelchairs were permitted....
-
Which accessibility guidelines must we use?
The technical provisions are now also more consistent with the model building codes, including the International Building Codes, and with industry standards such as the American National...
-
5.7.1 Lift Compatibility Clearance in Base for M301
5.7.1 Lift Compatibility Clearance in Base for M301 Description: For portable floor lifts to be effective, they must deploy at diagnostic equipment such that the boom of the lifts can...
-
Orientation (slide 12)
Floor-plan organization, if it’s consistent from floor to floor, it’s much easier for people to navigate....
-
§ 38.83(c)(5) Slope
If the height of the vehicle floor, under 50% passenger load, from which the ramp is deployed is 3 inches or less above the station platform a maximum slope of 1:4 is permitted; if the height...
-
11B-604.7.1 Dispensers
The outlet of the dispenser shall be below the grab bar, 19 inches (483 mm) minimum above the finish floor and shall not be located behind grab bars....
-
11B-809.9.3 Removable base cabinets
sinks and work surfaces provided that all of the following conditions are met: a) base cabinets can be removed without the use of specialized tools or knowledge; b) the finish floor...
-
11B-604.7.1 Dispensers
The outlet of the dispenser shall be below the grab bar, 19 inches (483 mm) minimum above the finish floor and shall not be located behind grab bars....
-
11B-809.9.3 Removable base cabinets
sinks and work surfaces provided that all of the following conditions are met: a) base cabinets can be removed without the use of specialized tools or knowledge; b) the finish floor...
-
H21
Is a horizontal grab bar at least 40 inches long securely mounted on the adjacent side wall 33 to 36 inches above the floor with one end no more than 12 inches from the back wall 33 to 36...
-
ACCESSIBLE ROUTE
Interior accessible routes may include corridors, floors, ramps, elevators, lifts, and clear floor space at fixtures....
-
Section 37.165 Lift and Securement Use
The same point applies to an OPMD and its user, subject to legitimate safety requirements....
-
Section 37.165 Lift and Securement Use
The same point applies to an OPMD and its user, subject to legitimate safety requirements....
-
G. Availability of Materials Incorporated by Reference
Availability: Copies of this standard may be obtained from the Institute of Electrical and Electronics Engineers (IEEE), 10662 Los Vaqueros Circle, P.O....
- Sioux Chief Closet Flange Family Animation Video
-
603.3 Mirrors
Mirrors located above lavatories or countertops shall be installed with the bottom edge of the reflecting surface 40 inches (1015 mm) maximum above the finish floor or ground....