Signage indicating special accessibility provisions shall be provided as shown: Each door providing access to an area of refuge from an adjacent floor area shall be identified by a...
Search Results "Door Height"
Filters
Commonly Searched Documents
-
1009.9 Signage
-
11B-608.3 Grab bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor....
-
205 and 309 Operable Parts
Standards, require operable parts on accessible elements, along accessible routes, and in accessible rooms and spaces to comply with the technical requirements for operable parts, including height...
-
6.3 Minority Reports
6.3 Minority Reports Because the Advisory Committee did not achieve consensus on the recommendation for a minimum transfer surface height standard, U.S....
-
407.12.3.2.2 Knee and Toe Space (Section-by-Section Analysis)
First, toe space with a reduced clear height of 9 inches (rather than 27 inches) would be permitted for a depth of no more than 6 inches....
-
4.34.4 CONSUMER INFORMATION
the owner or occupant of a dwelling, the following consumer information shall be provided in each adaptable dwelling unit available for occupancy: (1) Notification of the alternate heights...
-
III-7.5165 Signage
. , men's and women's rooms, room numbers, exit signs) must have raised and Brailled letters; must comply with finish and contrast standards; and must be mounted at a certain height and...
-
11B-608.3 Grab bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor....
-
11B-608.3 Grab bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor....
-
11B-411.2.1.2.3 Accessibility function button
The International Symbol of Accessibility shall comply with Section 11B-703.7.2.1, and shall be 5/8 inch (15.9 mm) minimum in height. The indication shall be three raised dots....
-
Question 16
What are appropriate bed heights to ensure accessibility by individuals with mobility disabilities and should there be requirements for mattresses to ensure that the height of the mattress...
-
viii. Hospital beds and gurneys
In order to permit transfers by individuals with mobility disabilities, including those using wheelchairs, accessible height-adjustable beds would allow persons using wheelchairs and other...
-
11B-225.2.3 Library book stacks
ETA Editor's Note The ADA Advisory identifies library shelving as self-service shelving, which does not have a height limitation....
-
4.29.7* STANDARDIZATION
Textured surfaces for tactile door warnings shall be standard within a building, facility, site, or complex of buildings....
-
Floor or Ground Surfaces: ADA Standard Section 304.2
Section 304.2 covers the current ADA Standards for the ground surfaces of a turning space.
-
12.2 Q. What happens if a builder deliberately manipulates the grade so that a second story, which also might have been treated as a ground floor, requires steps?
Deliberate manipulation of the height of the finished floor level to avoid the requirements of the Fair Housing Act would serve as a basis for the Department to determine that there is reasonable...
-
5b. Ramp Slope
[ADA Stds 4.7.2] Note: 1:12 is one inch of vertical height for 12 inches of horizontal distance. Yes _____ No _____...
-
Raised Crossings
Consult local Standards for application requirements, including slope for vehicle traffic, height, and markings....
-
11B-405.7 Landings
A level landing is needed at the accessible door to permit maneuvering and simultaneously door operation. FIGURE 11B-405.7 ‡‡ RAMP LANDINGS...
-
405.7 Landings
A level landing is needed at the accessible door to permit maneuvering and simultaneously door operation. Figure 405.7 Ramp Landings...
-
Adaptability
It is not intended to include moving walls, relocating plumbing, replacing fixtures, widening door frames, or other work more appropriately addressed in design and construction....
-
Rockwood Manufacturing Company K1038 .038" Thick - Metal Kick Plate
Material: .038" Aluminum, Stainless Steel Fastener: #6 x 5/8 OH SMS Ordering: Specify height x width x finish code. Add any options. Weight: 8" x 34" = 3.2 lbs....
-
Serving Counters
Serving Counters Where food or drinks are served at counters and the counter height is more than 34 inches above the floor, providing a lowered section of the serving counter at least...
-
11B-213.3.1 Toilet compartments
Full-height partitions and door assemblies can comprise toilet compartments where the minimum required spaces are provided within the compartment. ◼ ETA Editor's Note With the...
