Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
Search Results "Clear Width at Turn"
-
608.2.3 Alternate Roll-In Type Shower Compartments
-
Slope 2 - Endless Speed and Reflex Challenge
In this fast-paced experience, you control a ball rolling down an endless 3D track filled with sharp turns, gaps, and dangerous obstacles....
-
Sections 505.10.2 and 505.10.3
The requirement in the 1991 Standards that handrails extend horizontally at least 12 inches beyond the width of one tread at the bottom of a stair was changed in the 2004 ADAAG by the Access...
-
Sharing an Access Aisle
Requirements for access aisles in section 502.3 address width, length, marking, and location. Two spaces are permitted to share an access aisle....
-
1127B.5, Item 4
A level landing 4 feet (1219 mm) deep shall be provided at the upper end of each curb ramp over its full width to permit safe egress from the ramp surface, or the slope of the fanned or...
-
5.3.2 Transfer Sides Recommendations for M301
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface....
-
Construction Specification Institute
For longitudinal lines, measurements were to be taken in minimum 5 - foot lengths running parallel to the long dimension, with one measurement line per 3 feet of width and within 2 feet...
-
Other Sources
The Access Board used anthropometric data and other standards for the width of transfer surfaces on diagnostic equipment used by patients in a seated position (see M302.2.2), height of breast...
-
AD Systems’ Exam Room Doors
operation Soft closed dampening system prevents slamming Easy to clean aluminum frame system wraps and protects wall construction Hardware Options ADA thumb-turn...
-
Designed Use
For example, on a trail with Managed Uses of all-terrain vehicle and Motorcycle, all-terrain vehicle use would be the Designed Use because this use requires wider tread widths and has lower...
-
Diving into the Fun of Store Management Games (with a Twist of Drift Boss)
Risk Assessment: Each turn in drift boss presents a calculated risk. Do you take the turn wide for a smoother entry, or do you cut it close for a quicker lap time?...
-
1130A.1 General
The accessible route shall pass through the primary entry door, and shall connect with all additional exterior doors, required clear floor spaces at kitchen appliances and bathroom fixtures...
-
608.2.2 Standard Roll-In Type Shower Compartments
Standard roll-in type shower compartments shall be 30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
20. Does topping off a play surface trigger its replacement with an accessible surface?
surface along accessible routes located within the boundary of the play area, including the entry and exit points of the ground level play components required to be accessible, as well as at clear...
-
5.8.2.7 Base Support Allowance
Base support is permitted to obstruct the clear floor space if it fits within the allowed base support volume. Base supports can be a maximum of 1½ inches high....
-
Kitchens, Kitchenettes, or Wet Bars [9.2.2(7)]
Kitchens, Kitchenettes, or Wet Bars [9.2.2(7)] Clear floor space for either a forward or a side approach is permitted for cabinets, counters, sinks, and appliances....
-
Controls
Clear floor space at controls should be located outside the door swing....
-
Security Bollards [7.4] and Security Devices
Security Bollards [7.4] and Security Devices Bollards and rails used to keep shopping carts on the premises must allow an accessible clear passage (32 inches wide minimum) along at least...
-
Controls [9.2.2(5)]
Controls [9.2.2(5)] All controls in accessible units, sleeping rooms, and suites must comply with 4.27, which provides specifications for clear floor space, height of operable controls...
-
4.8.4 LANDINGS
(2) The landing length shall be a minimum of 60 in (1525 mm) clear....
-
604.8.1.6 Lavatory
The lavatory shall be mounted so as not to overlap the clear floor space areas required by section 604 for the wheelchair accessible toilet compartment and shall comply with section 606....
