Mitigation of changes in lighting levels such as between the outdoors and the interior, from one level of interior illumination to another, and within spaces between one surface and another...
Search Results "Tread Surface"
Filters
Commonly Searched Documents
-
Executive Summary
-
Viewing Areas
When the surface isn't paved or built with boards, allow grades up to 1:33 (3 percent) in any direction if needed for proper drainage....
-
Sales and Service Counters
This provides a lowered surface where goods and services and money can be exchanged. An alternative solution is to provide an auxiliary counter nearby....
-
TTYs
This included a requirement that the touch surface of TTY keypads be 30 to 34 inches high (704.4.1). Comment....
-
11B-703.4.2 Location
When tactile signs are mounted inconsistently on surrounding wall surfaces, or mounted on the door itself, they are difficult to find and may create a safety hazard....
-
M305.2.4 Cross Section (Section-by-Section Analysis)
The Access Board sought input in MDE NPRM preamble question 21, on whether the gripping surfaces of current transfer supports on different types of equipment meet the cross sectional dimensions...
-
5.8.1.1 Clear Platform Size Recommendation
33.8 34 -- -- -- 34.5 The Wheeled Mobility Anthropometry Project recommends a minimum flat surface...
-
T402 Ramps and Bridgeplates
The technical requirements for ramps and bridgeplates in the 2016 Non-Rail Vehicle Guidelines include provisions on design load, installation and operation, emergency operation, surfaces...
-
Water Hydrants
Locate water spouts between 28 inches (710 millimeters) and 36 inches (915 millimeters) above the ground or floor surface on the edge of a clear space that is at least 72 inches (1,830 millimeters...
-
F - number system
The flatness number also gives an indication of the "bumpiness" of the surface. The F - number system develops two number ratings, the FF and the FL....
-
11B-703.4.2 Location
When tactile signs are mounted inconsistently on surrounding wall surfaces, or mounted on the door itself, they are difficult to find and may create a safety hazard....
-
11B-703.4.2 Location
When tactile signs are mounted inconsistently on surrounding wall surfaces, or mounted on the door itself, they are difficult to find and may create a safety hazard....
-
American Specialties Retractable Shower Seat 170
Fabricated of 12 gauge stainless steel, exposed surfaces have a satin finish. Seat has reinforced channels. Wall sub frame furnished, with welded on masonry anchors....
-
Feature 1 - Parking and Passenger Drop-Off Areas
In order to be usable, the access aisle must be level, clear of gravel or mud, and the surface must be in good condition without wide cracks or broken pavement....
-
Vanity Counter Tops
The Board has removed the minimum surface requirement (2 square feet) for vanity counter tops....
-
Curb Ramps at Marked Crossings and Vehicular Lanes
width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured from the back of the curb on the ramp surface...
-
Benches
If benches are located in wet areas, the surface must be slip-resistant and designed not to accumulate water....
-
224.6 Housing at a Place of Education
suites and clustered sleeping rooms) or on floors containing accessible sleeping rooms with mobility features shall provide turning spaces that comply with section 809.2.2 and kitchen work surfaces...
-
3. Buttock-Popliteal Length
The median buttock-popliteal length provides an upper bound for the depth of a seating surface....
-
3.3 Data Sources
Early on, it became clear that some Committee members were unfamiliar with issues raised during transfers from a wheelchair or scooter onto a surface such as an examination table....
-
4.3.3 Imaging Equipment Used for Interventional and Biopsy Procedures with Sedated Patients
patients undergoing these procedures receive some form of sedation prior to transfer.CC When sedated, all patients – regardless of their physical abilities – are assisted onto the transfer surface...
-
Beach Access Routes
A beach access route is a continuous, unobstructed path that crosses the surface of the beach and provides pedestrians access to the water....
-
Front grab bar protocol
The preferred grab bar height was measured between the floor and the top of the grab bar surface. ...
-
Edge Protection [4.8.7]
A rail mounted close enough to the ramp surface to prevent passage of a 4 inch diameter sphere can function like a curb in keeping front casters from getting stuck on vertical posts and...
