If we look at 11B-904.4.1, we see that a 36” minimum long section of the counter needs to be installed at 34” maximum height. ...
Search Results "Seat Height"
Commonly Searched Documents
-
Service Counters
- Inclusion Solutions Model 2000 Voting Booth with Light (Hard Curtain)
- Inclusion Solutions Model 2000 Voting Booth (Hard Curtain)
-
Jean Tessmer
Some of us prefer to mount to allow 28" knee clearance minimum to give the person in the wheelchair a lower shelf height of 32" depending on the thickness of your new #200 baby changer shelf...
-
Storing Assistive Devices in the Aircraft Cabin
[Sec. 382.41(b)] You must permit passengers to stow their canes and other assistive devices in the cabin and close to their seats, consistent with FAA safety regulations concerning carry-on...
-
Issues Related to the Interactive Process and Return to Work
The employer asks if the employee could do seated work during the break; the doctor says yes....
-
Accessible Routes
For each accessible amusement ride, an accessible route is required to connect to a wheelchair space, a ride seat designed for transfer, or a transfer device for use with an amusement ride...
-
B.2.ii. - How should an agency proceed in identifying "applicable" technical provisions in Subparts B, C, and D of the Access Board’s standards to ensure acquired products provide comparable access?
For example, if an agency were to enter into a seat management contract for desktop computing resources, the hardware and software to be provided by the contractor would be required to meet...
- Adaptive Access
-
F. Electronic and information technology
While some POS devices are mounted at a height that fits within current reach range guidelines, the Department is aware that the fixed upward orientation of some of these devices can impede...
- Kompan, Inc. M175 - Water Lilies Spring Rider
- Belson Outdoors Recycled Plastic Universal Access Picnic Table
-
216 and 703 Signs
These types of signs include: seat and row designations in assembly areas; occupant names, building addresses; company names and logos; signs in parking facilities (except those identifying...
-
11B-209.4 Valet parking
Some vehicles may be adapted with hand controls or lack a driver’s seat, and may not be operable by a valet parking attendant....
-
Technical Memorandum TM 2013-11 Benches
Steam Rooms TAS 612.2 Dressing, Fitting, and Locker Rooms TAS 803.4 Holding Cells and Housing Cells TAS 807.2.2 Fixed or built-in benches and other types of fixed seating...
-
H29
Accessible Shower Stall Minimum Size and Clearances Accessible Shower Stall Grab Bars and Seat, Shower, and Control Area...
-
Access to Performing Areas [4.33.5]
While handrails are not required on ramps adjacent to assembly seating, locating aisles (including those that are stepped) along walls will permit handrails on one side for the benefit of...
-
Wheelchair Spaces
Wheelchair spaces should not overlap required exit widths or circulation paths and should provide for shoulder-to-shoulder alignment with occupants of adjacent seats (an important consideration...
-
Printable Room Layouts
If your meeting will have more than 10% of attendees using mobility devices or service animals, increase the number of accessible seating locations and aisle widths proportionally....
-
Error/Omission: When a transfer shower is used, it is often larger than the required 36" x 36" size.
Users may slide off the seat and fall onto the floor of the shower while reaching for the shower controls and hand-held showerhead. Requirement: 4.21.2 Size and Clearances....
-
1009.3.3 Area of Refuge
Areas of refuge are not required for smoke-protected or open-air assembly seating areas complying with Sections 1029.6.2 and 1029.6.3....
-
Shelves and Maneuvering Space
Items can be placed at any height but staff should be available to assist customers who may have difficulty reaching or viewing items....
-
Station 1-Physical Characteristics
Height-measured from the ground to the highest point on the device or vehicle or the top of the user's head, whichever is higher....
-
11B-504.8 Floor identification
11B-703.3 and 11B-703.5 shall be located at the landing of each floor level, placed adjacent to the door on the latch side, in all enclosed stairways in buildings two or more stories in height...