In transfer type shower compartments, the controls, faucets, and shower spray unit shall be installed on the side wall opposite the seat 38 inches (965 mm) minimum and 48 inches (1219 mm...
Search Results "Designated Aisle Seat (Assembly)"
Commonly Searched Documents
-
11B-608.5.1 Transfer type shower compartments
-
608 Shower Compartments
Section 608 addresses transfer showers and roll-in showers and provides specifications for size and clearances, grab bars, seats, operable parts, shower spray units, thresholds, and enclosures...
-
Side guard protocol
Side guard protocol: From initial setup, two side guards adjusted 6” (15.2 cm) higher than the subject’s WMD seat were attached, and subjects were asked to perform a level height transfer...
- Haws Barrier-Free Chilled Dual Wall Mount Fountain H1011.8
- Haws Barrier-Free Chilled Wall Mount Fountain H1001.8HPS
- Haws Barrier-Free Chilled Wall Mount Fountain H1001.8
-
Height
OWP&P used the high end of ADAAG (33") whereas Nelson Tremain used 10" above the seat height....
-
§382.85(a)(2)(i)
(i) When a passenger with a disability not described in §382.81 makes a reservation, you must assign to the passenger any seat, not already assigned to another passenger, that accommodates...
- Detecto 6550 Portable Wheelchair Scale Set-up
-
3. Stowage Space for Wheelchairs
It would apply only to aircraft with 100 or more seats....
-
Location: ADA Standard Section 407.4.7.1.2
Section 407.4.7.1.2 covers the current ADA Standards for the location of designations and indicators on elevator car control buttons.
- HEWI Life System Fixed Rectangular Mirror
- Kohler Numi Toilet
- Cybex Total Access Chest Press Exercise Machine
-
226 Dining Surfaces and Work Surfaces
exempt sales and service counters from this section, which are covered instead by section 227 (226.1, Exception 1) exempt check-writing surfaces at inaccessible check-out aisles...
-
9.4 POST OFFICE BOXES
Aisles between post office boxes shall be a minimum of 66 in (1675 mm) clear width....
-
11B-104.1 Dimensions
Dimensions stated as a "maximum" or "minimum" provide a dimensional range for design purposes....
-
3. Buttock-Popliteal Length
The median buttock-popliteal length provides an upper bound for the depth of a seating surface....
-
11B-903.3 Size
Benches shall have seats that are 48 inches (1219 mm) long minimum and 20 inches (508 mm) deep minimum and 24 inches (610 mm) deep maximum. [2010 ADA Standards] 903.3 Size....
- Kompan, Inc. Hammock ELE400006
-
Back Support
Commenters recommended clarification on the permitted horizontal distance of the back support from the rear edge of the seat....
-
Service Animal Issues
is where the animal blocks a space that, per FAA or applicable foreign government safety regulations, must remain unobstructed (e.g., an aisle, access to an emergency exit) AND the passenger...
-
233.1 General
Facilities with more than 50 beds covered by this part that provide common use bathing facilities shall provide at least one roll-in shower with a seat that complies with the relevant provisions...