., higher than 27 inches from the floor) and below the standard head room clearance (80 inches), are limited to a 4 inch depth....
Search Results "Floor Destination"
Filters
Commonly Searched Documents
-
307 Protruding Objects
-
105.2.1 ANSI/BHMA
Copies of the referenced standards may be obtained from the Builders Hardware Manufacturers Association, 355 Lexington Avenue, 17th floor, New York, NY 10017 (http://www.buildershardware.com...
-
Front grab bar protocol
The preferred grab bar height was measured between the floor and the top of the grab bar surface. ...
-
City of XXX – ADA Transition Plan
to accessible entrance Install sign 2/4 Facilities manager $40 Maintenance and repairs First floor...
-
Requirement 5. Light switches, electrical outlets, thermostats and other environmental controls in accessible locations.
thermostats and other environmental controls would meet section 100.205(c)(3)(ii) if operable parts of the controls are located no higher than 48 inches, and no lower than 15 inches, above the floor...
-
105.2.1 ANSI/BHMA
Copies of the referenced standards may be obtained from the Builders Hardware Manufacturers Association, 355 Lexington Avenue, 17th floor, New York, NY 10017 (http://www.buildershardware.com...
-
205.1 General
Floor electrical receptacles shall not be required to comply with 309. 5. HVAC diffusers shall not be required to comply with 309. 6....
-
i. Medical examination and treatment tables and chairs
course of its enforcement efforts that medical and dental examination tables and chairs often are too high to be accessible, lack stabilization elements, and do not have adequate clear floor...
-
Sight Lines
A variety of factors determine the quality of "vertical" sight lines, such as the distance from performance areas, row spacing, staggering of seats, and floor slope....
-
Gurney Accessible Bathroom
Slip-resistant tile (.6 CFR wet and dry) with multiple grout lines for traction Floor tile installed at a 2% slope for drainage Flexible threshold for easy use from a wheelchair...
-
Washing Machines; Clothes Dryers— Sections 214.2 and 214.3 of the 2010 Standards
would not require a laundry room on an upper story of a non-elevator building to be accessible provided that there is an accessible laundry room serving that same building on the ground floor...
-
III-4.1400 Surcharges
ILLUSTRATION: The ABC pharmacy is located on the second floor of an older four-story building that does not have an elevator....
-
1.1.1 Measurement tools
Digital inclinometers (SmartTool®), floor profilers, and other electronic instruments are capable of measuring to this accuracy. 0.01 ft accuracy for elevations is common in surveying and...
-
1009.9 Signage
Each door providing access to an area of refuge from an adjacent floor area shall be identified by a sign stating: AREA OF REFUGE. 2....
-
[2010 ADAS] 105.2.1 ANSI/BHMA
Copies of the referenced standards may be obtained from the Builders Hardware Manufacturers Association, 355 Lexington Avenue, 17th floor, New York, NY 10017 (http://www.buildershardware.com...
-
§ 38.175(a)
shall be coordinated with the boarding platform design such that the horizontal gap between a car door at rest and the platform shall be no greater than 3 inches and the height of the car floor...
-
5.8.1.1 Clear Platform Size Recommendation
Notes II The IDeA Center in its research defined wheelchair wheelbase as the distance from the center of the primary drive wheel to the center of the caster measured parallel to the floor...
-
Bed Height Fact Sheet
All beds (including the railings, box spring, and mattress) within a mobility accessible (ADA) room should be no higher than 23” and no lower than 17” above the floor surface....
-
T302 Walking Surfaces
Some flooring products are labeled with a slip resistance rating based on a laboratory test procedure....
-
Emergency Evacuation Preparedness: Take Responsibility for Your Safety
Ray, who has quadriplegia and works on the second floor, said it was the first fire drill in the 18 months he's worked there....
-
III-6.1000 General
ILLUSTRATION 1: Flooring in a store is being replaced. This is an alteration because it can affect whether or not an individual in a wheelchair can travel in the store....
-
11B-805.6 Hand washing fixtures, lavatories and sinks
Section 11B-306.3.3, Exception 1 which states: "At lavatories required to be accessible by Section 11B-213.3.4, the knee clearance shall be 27 inches (686 mm) high minimum above the finish floor...
-
11B-805.6 Hand washing fixtures, lavatories and sinks
Section 11B-306.3.3, Exception 1 which states: "At lavatories required to be accessible by Section 11B-213.3.4, the knee clearance shall be 27 inches (686 mm) high minimum above the finish floor...
-
Flush Controls on Toilets
Hand operated flush controls shall comply with 309.2 and 309.4 and shall be installed 36 inches (915 mm) maximum above the finish floor....