Beach access routes are required when dune crossings, stairways, or ramps leading from boardwalks to the beach are constructed or altered; when parking facilities, pedestrian routes, toilet...
Search Results "Curb Ramp Top Landing"
Commonly Searched Documents
-
Getting to the Water—Beach Access Routes
-
4. Organization of Technical Criteria
in a wheelchair (M303) Wheelchair space, including orientation, width, depth, knee and toe clearance, and surface slope Changes in level at entry to wheelchair space, including ramps...
-
Robert Dupuy, IALD, LC. Problems and Solutions
Examples of Integrating Daylighting with Electric Lighting (slide 2) The first photo on the top is about lighting controls, which are being now mandated by energy codes....
-
Section 36.406(f) Assembly Areas (Section-by-Section Analysis)
rear sixty percent (60%) of the seats provided in an auditorium; or (ii) It is located within the area of an auditorium in which the vertical viewing angles (as measured to the top...
-
Section 35.151(g) Assembly Areas (Section-by-Section Analysis)
the rear sixty percent (60%) of the seats provided in an auditorium; or (ii) it is located within the area of an auditorium in which the vertical viewing angles (as measured to the top...
-
11B-404.2.9 Door and gate opening force
At each location where vertical actuation bars are provided the operable portion shall be located so the bottom is 5 inches (127 mm) maximum above the floor or ground surface and the top...
-
1.2 Background
The tactile properties of detectable warning surfaces result from a grid pattern of raised, flat-topped, truncated domes that can be felt underfoot or detected by a long cane or a wheelchair...
-
III. ARCHITECTURAL ACCESS
Implementation of the plan for a systemwide survey of Kaiser facilities in California may proceed on a service area basis, provided that top priority will be placed on surveying and removing...
-
Standing Supports (M304.3 and M305.3)
The top of the gripping surface would be required to be 34 inches minimum and 38 inches maximum above the standing surface....
-
11B-404.2.9 Door and gate opening force
At each location where vertical actuation bars are provided the operable portion shall be located so the bottom is 5 inches (127 mm) maximum above the floor or ground surface and the top...
-
11B-404.2.9 Door and gate opening force
At each location where vertical actuation bars are provided the operable portion shall be located so the bottom is 5 inches (127 mm) maximum above the floor or ground surface and the top...
- Viking E-1600A-BLT2EWP Emergency Tower Phone with Blue Strobe Light, Voice Announcer and Weather Protection
- Symmetry Limited Use/Limited Application (LU/LA) Elevator
- Lutron Sivoia QED Kirbé Vertical Motorized Drapery System
- Listen Technologies iDSP Prime Level III Stationary RF System Personal Listening Product
- Spectrum Industries Inc. Freedom One Sit-to-Stand Lectern™ Adjustable Height Lecterns
- Hadrian Inc. Specialty Lockers
- Populas Accella Adjustable Activity / Computer Workstation
- Spectrum Industries Inc. Instructor Media Console and Workstation
-
Assessment factors. (Section-by-Section Analysis)
wheelchair; (2) the potential risk of harm to others by the operation of the mobility device; (3) the risk of harm to the environment or natural or cultural resources or conflict with Federal land...
-
Separate Pathways for Pedestrians and Bicyclists
The impact of such a requirement if applied to the full length of all shared use paths would likely result in many not being constructed due to the increased costs associated with more land...
-
1.1.3.2 State-regulated buildings, structures, and applications
Marine Oil Terminals regulated by the California State Lands Commission. See Section 1.14 for additional scope provisions....
-
1.1.3.2 State-regulated buildings, structures, and applications
Marine Oil Terminals regulated by the California State Lands Commission. See Section 1.14 for additional scope provisions....
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
limited to, one or more of the following items shall be limited to the actual scope of work of the project and shall not be required to comply with Section 11B-202.4: Installing ramps...