Section 306.2.1 of the ADA Standards covers information in the current ADA Standards for toe clearance.
Search Results "Commercial Place of Public Amusement"
Filters
Commonly Searched Documents
-
General: ADA Standard Section 306.2.1
-
Height: ADA Standard Section 407.3.3.1
Section 407.3.3.1 covers the current ADA Standards for the height requirements of an elevators reopening device.
-
General: ADA Standard Section 406.1
Section 406.1 of the ADA Standards covers information in the current ADA Standards for curb ramps.
-
Signal Type: ADA Standard Section 407.4.8.2.1
Section 407.4.8.2.1 covers the current ADA Standards for the signal type of audible elevator car indicators.
-
Size: ADA Standard Section 407.4.6.2.1
Section 407.4.6.2.1 covers the current ADA Standards for the size of the elevator car control buttons.
-
Arrangement: ADA Standard Section 407.4.6.2.2
Section 407.4.6.2.2 covers the current ADA Standards for the arrangement of the elevator car control buttons.
-
Contact: ADA Standard Section 407.3.3.2
Section 407.3.3.2 covers the current ADA Standards for the contact requirements of an elevators reopening device.
-
Door and Signal Timing: ADA Standard Section 407.3.4
Section 407.3.4 covers the current ADA Standards for door and signal timing of elevator reopening devices.
-
Location: ADA Standard Section 604.9.1
Section 604.9.1 covers the current ADA Standards for the mounting location of children's use water closets.
-
3. Automatic Call Distribution (ACD)
ACD places incoming calls into a queue, sends out a programmed message to callers to let them know that their calls have been received, and distributes calls to the next available call taker...
-
Q: What is HCO? Who uses it?
HCO can be accomplished by a call taker using standard stand-alone TTY equipment by alternating speaking into the handset and placing the handset in the TTY when the caller types a response...
-
11B-809.5.5.2 Identification
Such peepholes can be placed at a standard height and permit a view from several feet from the door....
-
T402.2 Design Load
Ramps and bridgeplates 30 inches (760 mm) or more in length shall be designed to support a load of 600 pounds (273 kg) minimum, placed at the centroid of the ramp distributed over an area...
-
Adjustable gap protocol
Adjustable gap protocol: From initial setup, just the horizontal distance between the WMD and platform was incrementally increased by placing plywood blocks of 3.5” (8.9cm) width between...
-
Architectural Barriers
Assuming your place of lodging is not subject to the new construction and alteration provisions (discussed below), you must remove barriers to access for people with disabilities when it...
-
604.8.2.2 Doors
A door pull complying with 404.2.7 shall be placed on both sides of the door near the latch. Toilet compartment doors shall not swing into the minimum required compartment area....
-
809.5.5.2 Identification
Such peepholes can be placed at a standard height and permit a view from several feet from the door....
-
12162(a)(4)(A)(ii)
Unless not practicable, a person providing intercity rail transportation shall place an accessible car adjacent to the end of a dining car described in clause (I) through which an individual...
-
1016.6 Openings
Elongated openings should be placed so that the long dimension is perpendicular, or as close to perpendicular as possible, to the dominant direction of travel....
-
11B-809.5.5.2 Identification
Such peepholes can be placed at a standard height and permit a view from several feet from the door....
-
11B-221.2 Wheelchair spaces
NOTE: When required wheelchair spaces are not occupied by persons eligible for those spaces, individual, removable seats may be placed in those spaces. ...
-
11B-809.5.5.2 Identification
Such peepholes can be placed at a standard height and permit a view from several feet from the door. ◼...