(A) employees comply with the standards established in such regulations of the Department of Defense, if the employees of the covered entity are employed in an industry subject to such regulations...
Search Results "Electroacoustic Performance Standards"
Filters
Commonly Searched Documents
-
12114(c)(5)(A)
-
M101.3 Existing Diagnostic Equipment
The MDE Standards do not address the applicability of scoping or technical requirements to existing diagnostic equipment....
-
F106.3 Undefined Terms
Administration, the Secretary of Defense, the Secretary of Housing and Urban Development, or the United States Postal Service to implement the Architectural Barriers Act or in referenced standards...
-
A. Chapter 2: M201 Scoping
In the final rule, Chapter 2 establishes that the enforcing authority will determine the number and types of diagnostic equipment to which the MDE Standards will apply....
-
601.1 Scope
documentation and services where required by 508 Chapter 2 (Scoping Requirements), 255 Chapter 2 (Scoping Requirements), and where otherwise referenced in any other chapter of the Revised 508 Standards...
-
§27.13(b) Adoption of complaint procedures.
A recipient shall adopt procedures that incorporate appropriate due process standards and provide for the prompt and equitable resolution of complaints alleging any action prohibited by...
-
E202.6 Undue Burden or Fundamental Alteration
Where an agency determines in accordance with E202.6 that conformance to requirements in the Revised 508 Standards would impose an undue burden or would result in a fundamental alteration...
-
13. Amend § 36.406 as follows:
Add the heading Applicable standards to paragraph (a); b. Redesignate paragraph (a) as paragraph (a)(1); c. Revise paragraphs (a)(1) and (b); d. ...
-
§ 35.150(b)(4)(ii)
the applicable requirements for swimming pools, except that it shall provide at least one accessible means of entry that complies with section 1009.2 or section 1009.3 of the proposed standards...
-
M15
[ADA Standards §§ 4.23.7; 4.27; 4.4.1; Fig. 8] Yes No...
-
H14
[ADA Standards §§ 4.23.7; 4.27; 4.4.1; Fig. 8] Yes No...
-
e-vi
[ADA Standards § 4.10.5] Yes No...
-
C1-d
[ADA Standards § 4.3.8] Yes No Note: Level changes between 1/4 inch and 1/2 inch should be beveled (sloped) at 1:2 maximum....
-
12114(c)(5)(A)
(A) employees comply with the standards established in such regulations of the Department of Defense, if the employees of the covered entity are employed in an industry subject to such regulations...
-
503.2 User Preferences (Section-by-Section Analysis)
This closely corresponds to § 1194.21(g) in the existing 508 Standards....
-
E202.5.1 Basis for a Determination of Undue Burden
In determining whether conformance to requirements in the 508 Standards would impose an undue burden on the agency, the agency shall consider the extent to which conformance would impose...
-
III-7.8700 Transportation facilities
There are currently no standards for boats or ferry docks....
-
Exceptions for Specific Occupancies [§206.2.3]
Exceptions for Specific Occupancies [§206.2.3] The Standards also include limited exceptions for accessible routes between stories in air traffic control towers and, under certain...
-
Handles, Pulls, and Knobs
Standard U-shaped pulls and lever-shaped handles are acceptable. Stationary knobs with a shape that can be loosely gripped also are acceptable....
-
§ 37.17(b) Adoption of complaint procedures
An entity shall adopt procedures that incorporate appropriate due process standards and provide for the prompt and equitable resolution of complaints alleging any action prohibited by this...
-
Section 1194.1 Purpose (Preamble, Section-by-Section Analysis)
Section 1194.1 Purpose (Preamble, Section-by-Section Analysis) This section describes the purpose of the standards which is to implement section 508 of the Rehabilitation Act of 1973,...
-
§ 37.17(b) Adoption of complaint procedures
An entity shall adopt procedures that incorporate appropriate due process standards and provide for the prompt and equitable resolution of complaints alleging any action prohibited by this...
-
11B-703.5.7 Stroke thickness
[2010 ADA Standards] 703.5.7 Stroke Thickness. Stroke thickness of the uppercase letter "I" shall be 10 percent minimum and 30 percent maximum of the height of the character....
-
11B-806.3.1 Alarms
[2010 ADA Standards] 806.3.1 Alarms. Where emergency warning systems are provided, alarms complying with 702 shall be provided....