Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
Search Results "Segment Length"
-
Dimensions: ADA Standard Section 810.2.2
-
§382.117(a)(2)
(2) On a flight segment scheduled to take 8 hours or more, you may, as a condition of permitting a service animal to travel in the cabin, require the passenger using the service animal to...
-
Georgia-Pacific ® Translucent Smoke Push Paddle Roll Paper Towel Dispenser
The contemporary design fits perfectly in a variety of market segments including manufacturing, schools, and high-traffic areas....
-
Key Differences Between Routes
Technical Requirements for Slope If Running Slope of Segment is Steeper Than But Running Slope of Segment is Not Steeper Than Maximum Length of Segment Cross Slope...
-
§382.157(b)
As a foreign carrier, you are covered by this section only with respect to disability-related complaints associated with any flight segment originating or terminating in the United States...
-
1016.8.2 Width
Where resting intervals are provided within an outdoor recreation access route, resting intervals shall be at least as wide as the widest segment of the outdoor recreation access route leading...
-
1016.8.2 Width
Where resting intervals are provided within an outdoor recreation access route, resting intervals shall be at least as wide as the widest segment of the outdoor recreation access route leading...
-
11B-406.5.10 Diagonal curb ramps
Diagonal curb ramps with flared sides shall have a segment of curb 24 inches (610 mm) long minimum located on each side of the curb ramp and within the marked crossing....
-
4.8.5* HANDRAILS
Handrails shall comply with 4.26 and shall have the following features: (1) Handrails shall be provided along both sides of ramp segments....
-
Minimum Rear Wall Required.
It appears that this comment references the 2010 ADA Standards for Accessible Design for minimum bench length (42") but uses the CA - 2013 minimum bench length (48") to develop the minimum...
-
Passing Spaces [1017.4]
Where the full length of a trail does not fully comply with the trail technical requirements, a passing space must be located at the end of the trail segment that complies fully with the...
-
Turning Space: ADA Standard Section 809.2.2
However, the overlap of turning space must be limited to one segment of the T-turn so that back-up maneuvering is not restricted....
-
11B-226.3 Dining surfaces exceeding 34 inches in height
Where food or drink is served for consumption at a counter exceeding 34 inches (864 mm) in height, a portion of the main counter 60 inches (1525 mm) minimum in length shall be provided in...
-
11B-226.3 Dining surfaces exceeding 34 inches in height
Where food or drink is served for consumption at a counter exceeding 34 inches (864 mm) in height, a portion of the main counter 60 inches (1525 mm) minimum in length shall be provided in...
-
Designed Use
There is only one “Designed Use” per trail or trail segment....
-
2.5.3 Width
Where resting intervals are provided within an outdoor recreation access route, resting intervals shall be at least as wide as the widest segment of the outdoor recreation access route leading...
-
11B-607.2 Clearance
Clearance in front of bathtubs shall extend the length of the bathtub and shall be 48 inches (1219 mm) wide minimum for forward approach and 30 inches (762 mm) wide minimum for parallel...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
11B-607.2 Clearance
Clearance in front of bathtubs shall extend the length of the bathtub and shall be 48 inches (1219 mm) wide minimum for forward approach and 30 inches (762 mm) wide minimum for parallel...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
604.5.2 Rear Wall Grab Bar Location
This video demonstrates how to take the measurements of the length of a rear grab bar and the lateral position of a rear grab bar....
-
1017.4 Passing Spaces
Where the full length of a trail does not fully comply with the technical requirements in 1017, a passing space is required to be located at the end of the trail segment that fully complies...
-
Boat Slips: ADA Standard Section 1003.2.1
Where an existing gangway or series of gangways is replaced or altered, an increase in the length of the gangway shall not be required to comply with 1003.2 unless required by 202.4....
-
11B-1003.2.1 Boat slips
Exceptions: Where an existing gangway or series of gangways is replaced or altered, an increase in the length of the gangway shall not be required to comply with Section 11B-1003.2...
