Access Board's Note to Reader at Detectable Warnings....
Search Results "Raised Diving Board"
Filters
Commonly Searched Documents
-
11B-406 Curb ramps, blended transitions and islands
-
810.5.3 Platform and Vehicle Floor Coordination--Modification to 810.5.3 of Appendix D to 36 CFR Part 1191
EXCEPTION: Where vehicles are boarded from sidewalks or street-level, low-level platforms shall be permitted to be less than 8 inches (205 mm)....
-
11B-406 CURB RAMPS, BLENDED TRANSITIONS AND ISLANDS
Access Board's Note to Reader at Detectable Warnings....
-
Recreational Boating Facilities: ADA Standard Section 206.2.10
Section 206.2.10 covers scoping requirements in the most current ADA Standards for accessible routes to recreational boating facilities
-
FAQ: How do I submit a job for the Job Board?
To submit details of a job opening to add to the Job Board, you may either: 1. Click on the "FEEDBACK OR HELP" button that appears on every page of Corada. 2....
-
11B-206.2.10 Recreational boating facilities
Boat slips required to comply with Section 11B-235.2 and boarding piers at boat launch ramps required to comply with Section 11B-235.3 shall be on an accessible route....
-
11B-810.2.3 Connection
Bus stop boarding and alighting areas shall be connected to streets, sidewalks, or pedestrian paths by an accessible route complying with Section 11B-402....
-
§ 38.23(b)(10) Platform movement
(10) Platform movement. No part of the platform shall move at a rate exceeding 6 inches/second during lowering and lifting an occupant, and shall not exceed 12 inches/second during...
-
§ 38.83(a)
(a)
-
407.4.7.2 Keypads
The number five key shall have a single raised dot. The dot shall be 0.118 inch (3 mm) to 0.120 inch (3.05 mm) base diameter and in other aspects comply with Table 703.3.1....
-
407.4.7.2 Keypads
The number five key shall have a single raised dot. The dot shall be 0.118 inch (3 mm) to 0.120 inch (3.05 mm) base diameter and in other aspects comply with Table 703.3.1....
-
407.4.7.2 Keypads
The number five key shall have a single raised dot. The dot shall be 0.118 inch (3 mm) to 0.120 inch (3.05 mm) base diameter and in other aspects comply with Table 703.3.1....
-
810.2.2 Dimensions--Modification to 810.2.2 of Appendix D to 36 CFR Part 1191
810.2.2 Dimensions--Modification to 810.2.2 of Appendix D to 36 CFR Part 1191 Bus boarding and alighting areas shall provide a clear length of 96 inches (2440 mm), measured perpendicular...
-
Level boarding
If not using a lift or ramp to provide level boarding, the grantee must submit to FTA a demonstration of equivalent facilitation....
-
703.2.6 Stroke Thickness
703.2.6 Stroke Thickness. Stroke thickness of the uppercase letter "I" shall be 15 percent maximum of the height of the character.
-
11B-703.2.6 Stroke thickness
Stroke thickness of the uppercase letter “I” shall be 15 percent maximum of the height of the character.
-
11B-407.4.6.2 Buttons
Car control buttons with floor designations shall comply with Section 11B-407.4.6.2. Exception: Reserved. [2010 ADAS] EXCEPTION: In existing elevators, buttons shall be...
-
703.2.6 Stroke Thickness
Stroke thickness of the uppercase letter "I" shall be 15 percent maximum of the height of the character.
-
407.4.7.1.1 Type
Control buttons shall be identified by tactile characters complying with 703.2.
-
703.2.6 Stroke Thickness
Stroke thickness of the uppercase letter "I" shall be 15 percent maximum of the height of the character. [ECTCR UFAS 4.30.4]
-
407.4.7.1.1 Type
Control buttons shall be identified by tactile characters complying with 703.2.
-
407.4.7.1.1 Type
407.4.7.1.1 Type. Control buttons shall be identified by tactile characters complying with 703.2.
-
11B-407.4.6.2 Buttons
Car control buttons with floor designations shall comply with Section 11B-407.4.6.2. Exception: Reserved. [2010 ADAS] EXCEPTION: In existing elevators, buttons shall be...
-
11B-703.2.6 Stroke thickness
11B-703.2.6 Stroke thickness. Stroke thickness of the uppercase letter “I” shall be 15 percent maximum of the height of the character.