Locations: Offices Hospital/assisted living/ patient rooms Hotel rooms K-12 and university classrooms Other areas where signage must accommodate...
Search Results "Wheelchair Location"
Filters
Commonly Searched Documents
-
Takeform Fusion Signage Office/Suite/Room Identification Type H
-
Allen Tel Emergency Phone Automatic Ring Down - No Dial
programmable to disconnect on silence or a time out of thirty seconds to ninety-nine minutes Braille labeling Two LED lamps to indicate "on" and "help on the way" I.D. tones to indicate location...
-
Allen Tel Emergency Phone Automatic Ring Down Circuit - Single Number Dial
programmable to disconnect on silence or a time out of thirty seconds to ninety-nine minutes Braille labeling Two LED lamps to indicate "on" and "help on the way" I.D. tones to indicate location...
-
Expert opinion on the current literature
Titles and abstracts of the articles were reviewed internally by two experts with at least four years of direct clinical and research experience working with full-time wheelchair users. ...
-
3.3.6 Knee Clearance Height, minimum
BS8300 results for knee clearance height suggest that current U.K. standard generally accommodates most wheelchair users in that country....
-
Energy Requirements for Different Surfaces
0.37 1.31 Rest = Resting energy consumption (mlO2/kg/min) AwLM Ambulatory with limited mobility NoDis No known disability Wc Manual wheelchair...
-
Accessible Pathway & Corridor: Minimum Clear Width Required for 180-degree Turn
Findings from the Anthropometry of Wheeled Mobility Study indicate that a width of at least 130 cm (51 in.) was required for 50% of the manual wheelchair users measured in this study to...
-
3.3.11 180-Degree Turn
The U.S. standard of 1525 mm (60 in.) accommodates just over 80% of the manual and powered wheelchair users, but less than 50% of the scooter users in our sample....
-
3.3.15.2 Side (lateral) reach - unobstructed
For heights of 500‒600 mm only 48% of manual wheelchair users, 32% of power wheelchair users and 22% of scooter users could complete a reach beyond the most lateral portion of their WhMD...
-
§382.57(c)(5)(i)(D)(1)
(1) Automated airport kiosk location, date and time of transaction, customer account numbers, and the kiosk identifier are not required to be audible;...
-
Side Transfer Surface
A transfer surface located within the length of the examination surface that allows patient transfer on two opposing sides of the examination surface....
-
M305.2.1.1 End Transfer Supports
Transfer supports for transfer surfaces complying with M301.2.3.1 and M302.2 shall be located on the short side (length) opposite the transfer side....
-
Facility
Facility - All or any portion of buildings, structures, site improvements, elements, and pedestrian routes or vehicle ways located on a site...
-
Facility
All or any portion of buildings, structures, improvements, elements, and pedestrian or vehicular routes located in the public right-of-way....
-
§27.71(k)(5)(i)(D)(1)
(1) Automated airport kiosk location, date and time of transaction, customer account numbers, and the kiosk identifier are not required to be audible;...
-
§ 382.57(c)(5)(i)(D)(1)
(1) Automated airport kiosk location, date and time of transaction, customer account numbers, and the kiosk identifier are not required to be audible;...
-
§ 27.71(k)(5)(i)(D)(1)
(1) Automated airport kiosk location, date and time of transaction, customer account numbers, and the kiosk identifier are not required to be audible;...
-
11.3 Q. The site analysis test calls for a calculation of the percentage of the buildable areas having slopes of less than 10 percent. What is the definition of buildable areas?
The buildable area is any area of the lot or site where a building can be located in compliance with applicable codes and zoning regulations....
-
Facility
All or any portion of buildings, structures, site improvements, elements, and pedestrian routes or vehicular ways located on a site....
-
11B-1008.2.6.2 Use zones
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition)....
-
4.7.6 Built-up Curb Ramps
Built-up curb ramps shall be located so that they do not project into vehicular traffic lanes (see Fig. 13)....
-
4.3.11.1(4)
(4) A vestibule located immediately adjacent to an exit enclosure and constructed to the same fire-resistive standards as required for corridors and openings....
-
4.7.6 BUILT-UP CURB RAMPS
Built-up curb ramps shall be located so that they do not project into vehicular traffic lanes (see Fig. 13)....
-
11B-1008.2.6.2 Use zones
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition)....
