methods to make communication accessible to people with hearing disabilities; providing qualified readers, taped texts, or other methods to make information accessible to people with visual...
Search Results "Character Height (Visual)"
-
1.Tax Credit for Small Business (Section 44 of the Internal Revenue Code)
-
Introduction
I’ve been visually impaired pretty much since birth. Consequently, I think that perhaps I pass a little better than folks who acquire a vision impairment later....
-
Issue 16: What environmental and perceptual data on artificial/electric lighting are available from buildings with low vision occupants?
Is this [RP 28-07 ANSI/IES Standard: Lighting and the Visual Environment for Senior Living] based on some hard data research that was done? Response by Eunice Noell-Waggoner....
-
18. Preemployment inquiries
For example, an employer may not ask on an employment form if an applicant is visually impaired but may ask if the person has a current driver's license (if that is a necessary qualification...
-
ADA Team
People with physical, visual, hearing, speech, intellectual, learning, behavioral health, and other disabilities may be included on the team. ...
-
Web Accessibility
The major categories of disability that WCAG addresses are visual, hearing, motor and cognitive....
-
National Braille Association
Association, founded in 1945, is a non-profit organization dedicated to providing continuing education to those who prepare braille, and to providing braille materials to persons who are visually...
-
Falls and Injuries
Visual acuity loss turns out to be a major independent risk factor for hip fractures. I’ll give you those numbers in a minute....
-
II-8.2000 Self-evaluation
direct access to individuals who use TDD's and computer modems. 4) A public entity should review its policies to ensure that they include provisions for readers for individuals with visual...
-
Standards that measure needed physical or mental ability to perform a job
Possible accommodations might include lowering the shelf-height, providing a step stool or other assistive device....
-
11B-703.3.1 Dimensions and capitalization
dots in the same cell1 0.100 (2.5 mm) Distance between corresponding dots in adjacent cells1 0.300 (7.6 mm) Dot height...
-
11B-404.2.10 Door and gate surfaces
stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch (254 mm) bottom smooth surface height...
-
F226.1 General
Consider work surfaces that are flexible and permit installation at variable heights and clearances....
-
5.4.2.2 Transfer and Positioning Support Length Recommendations for Imaging Equipment with Transfer Surfaces
A positioning support (for transfer surfaces >24” deep) is to extend horizontally along the side of the patient scanning/imaging bed/table with a length of 12 to 16 inches and a height...
-
Using the ORAR Exceptions [F202.3, Exception 4 and 1016, Exceptions 1, 2, and 3]
instance, where traffic calming devices, gates, or other barriers are provided on a paved roadway, the ORAR must have a clear width of 36 inches and obstacles cannot exceed one-half inch in height...
-
Seat Width Evaluation
seat was the smallest of the platform seat widths available in this study and was suitable for many participants (the 25th through 95th percentiles) for their level, highest and lowest height...
-
Alterations
is defined as remodeling, renovating, rehabilitating, reconstructing, changing or rearranging structural parts or elements, changing or rearranging plan configuration of walls and full-height...
-
The Purpose of FSORAG and FSTAG
included (scoping); what has to comply with the guidelines; definitions of terms; and technical requirements defining the physical characteristics of accessible features, such as width, height...
-
4.16.6 Dispensers
As a result, the dispenser was located 24" above the floor, 5" higher than the minimum height in ADAAG, and 42" from the rear wall (Figure 13), which would have been too high and too far...
-
Additional Features of Van-Accessible Parking Spaces
Vertical clearance of 98 inches minimum to accommodate van height at the vehicle parking space, the adjacent access aisle, and on the vehicular route to and from the van-accessible space...
-
11B-703.3.1 Dimensions and capitalization
1.6 mm) Distance between two dots in the same cell1 0.100 (2.5 mm) Distance between corresponding dots in adjacent cells1 0.300 (7.6 mm) Dot height...
-
11B-404.2.10 Door and gate surfaces
stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch (254 mm) bottom smooth surface height...
-
11B-404.2.10 Door and gate surfaces
stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch (254 mm) bottom smooth surface height...
