In other than rooms or spaces used for assembly purposes and Group B and M occupancies, the minimum clear aisle capacity shall be determined by Section 1005.1 for the occupant load served...
Search Results "Minimum Dimension"
-
1018.5 Aisles in other than assembly spaces and Groups B and M
-
405.8 Handrails
Ramps not subject to the exception to 405.5 shall be designed to maintain a 36 inch (915 mm) minimum clear width when handrails are installed....
-
804.2.1 Pass Through Kitchen
appliances or cabinets are opposite a parallel wall, clearance between all opposing base cabinets, counter tops, appliances, or walls within kitchen work areas shall be 40 inches (1015 mm) minimum...
-
409.3.1 Power Operation
Power operated doors and gates shall remain open for 20 seconds minimum when activated....
-
809.5.5.2 Identification
A means for visually identifying a visitor without opening the residential dwelling unit entry door shall be provided and shall allow for a minimum 180 degree range of view....
-
607.4.1.1 Back Wall
Two grab bars shall be installed on the back wall, one located in accordance with 609.4 and the other located 8 inches (205 mm) minimum and 10 inches (255 mm) maximum above the rim of the...
-
Detectable Warning Surfaces at Shared Use Path Intersections
The edge of the detectable warning surface would be installed between 6 inches minimum and 12 inches maximum from the edge of the intersecting segments of the shared use paths and sidewalks...
-
R304.5.1.2 Shared Use Paths
As proposed in the NPRM, R304.5.1 would require the clear width of curb ramp runs (excluding flared sides), blended transitions, and turning spaces to be 4 feet minimum....
-
Horse Accessible Gates
This gate is not accessible because it is narrower than the minimum width required for passage of a wheelchair (32 inches) and the bar across the opening is higher than 1 inch....
-
Dune Crossings [1018.10]
When a dune crossing is part of a beach access route, the clear width of the beach access route may be reduced from a minimum of 60 inches to a minimum of 48 inches....
-
Transit Stops (R308.1) (Section-by-Section Analysis)
Transit Stops (R308.1) (Section-by-Section Analysis) Boarding and alighting areas at sidewalk or street level transit stops must be 2.4 meters (8 feet) minimum measured perpendicular...
-
2.3.4 Analysis of Door Use Difficulty
Specifically, the percentage of each of the rating scores (minimum effort, moderate effort, maximum effort and impossible) was calculated for each of the three doors and six door use tasks...
-
11B-606.6 Adjacent side wall or partition
Lavatories, when located adjacent to a side wall or partition, shall be a minimum of 18 inches (457 mm) to the centerline of the fixture....
-
11B-809.5.5.2 Identification
A means for visually identifying a visitor without opening the residential dwelling unit entry door shall be provided and shall allow for a minimum 180 degree range of view....
-
602 Drinking Fountains
references to water coolers (602.1) requiring all wheelchair accessible drinking fountains to provide knee and toe clearance for a forward approach (602.2) lowering the minimum...
-
M301.2.2 Sunset Provision (Section-by-Section Analysis)
The Access Board intends to complete the necessary research to determine an appropriate minimum low transfer height prior to the effective date of the sunset, and will update this provision...
-
M302.2.2 Sunset Provision (Section-by-Section Analysis)
The Access Board intends to complete the necessary research to determine an appropriate minimum low transfer height prior to the effective date of the sunset, and will update this provision...
-
406.4 Landings
The landing clear length shall be 36 inches (915 mm) minimum. The landing clear width shall be at least as wide as the curb ramp, excluding flared sides, leading to the landing....
-
Clearances
The 80-inch minimum vertical clearance requirement remains for circulation areas and accessible routes in the queue line and load and unload areas....
-
7(2)(b)(vii)
A minimum clear floor space 2'6" wide by 4'0" should be available outside the stall. (See Figure 7(d).)...
-
11B-502.6.4.1
The parking space shall be marked with an International Symbol of Accessibility complying with Section 11B-703.7.2.1 in white on a blue background a minimum 36 inches wide by 36 inches high...
-
Clear Tread Width of Trails
An exception permits the width to be reduced to 32 inches (815 millimeters) minimum if a condition for an exception prevents the wider tread....
-
4.3.11.1(7)
Pressurization equipment and its duct work within the building shall be separated from other portions of the building by a minimum two-hour fire-resistive construction....