If seating for people in wheelchairs is provided at tables, counters, and work surfaces, knee spaces at least 27 in (685 mm) high, 30 in (760 mm) wide, and 19 in (485 mm) deep shall be provided...
Search Results "Check Writing Surface"
-
4.32.3 KNEE CLEARANCES
-
Advice for Passengers with Service Animals
Remember that your assigned seat may be reassigned if you fail to check in on time; airlines typically release seat assignments not claimed 30 minutes before scheduled departure....
-
If Carrier Contends That Attendant Is Required for Safety Reasons and Passenger Disagrees
[Sec. 382.35(d)] For purposes of determining whether a seat is available for an attendant, the attendant must be deemed to have checked in at the same time as the passenger with a disability...
-
Georgia-Pacific enMotion® Automated Touchless Soap and Sanitizer Dispenser
Maintenance is a breeze with a sight window allowing for quick check of soap level and an on/off switch for maintenance or cleaning. *Only available for lease from GP....
-
Cal-Royal CR801 Series Hydraulic Door Closers
Non-handed for standard, top-jamb or parallel arm installation Hydraulic door closer with standard adjustable back-check function Non-sized, 1 thru 6....
-
Oval Window Audio Induction Loop Receivers for Individuals without Telecoil-Equipped Hearing Aids
400mA/meter) Maximum 110 dBA SPL output (re: 400 mA/meter) Powered by 9 volt battery (included) for 50+ hour life Rechargeable with optional battery & charger Battery condition check...
-
NetCentric Technologies Inc. CommonLook PDF Validator Software
Some PDF verification products only check against PDF/UA....
-
Section 36.302 Modifications in Policies, Practices, or Procedures (Preamble, Section-by-Section Analysis)
One example of application of this principle is specifically included in a new § 36.302(d) on check-out aisles....
-
Section 36.302 Modifications in Policies, Practices, or Procedures (Section-By-Section Analysis and Response to Comments)
One example of application of this principle is specifically included in a new Sec.36.302(d) on check-out aisles....
-
1009.5.7 Grab Bars
Where a grab bar is provided on each step, the tops of gripping surfaces shall be 4 inches (100 mm) minimum and 6 inches (150 mm) maximum above each step and transfer platform....
-
1016.5 Obstacles
EXCEPTION: Where the surface is other than asphalt, concrete, or boards, obstacles shall be permitted to not exceed 1 inch (25 mm) in height measured vertically to the highest point....
-
11B-1002.5 Amusement ride seats designed for transfer
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
1002.5 Amusement Ride Seats Designed for Transfer
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
Transfer Platforms
can use to lift or transfer onto the play structure and leave the wheelchair or mobility device behind at ground level. 11 inches (280 mm) to 18 inches (455 mm) height of top surface...
-
1002.5 Amusement Ride Seats Designed for Transfer
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
11B-505.10.3 Bottom extension at stairs
Extension shall return to a wall, guard, or the landing surface, or shall be continuous to the handrail of an adjacent stair flight....
-
Finish and Contrast [4.30.5]
Consideration should also be given to light sources and the ambient lighting to prevent glare on sign surfaces....
-
Roughness Measurement
The surface profiles were measured with a custom-built pathway measurement tool (PathMeT), which was created from a power WC frame that was instrumented with a wheel encoder and an Acuity...
-
1016.5 Obstacles
EXCEPTION: Where the surface is other than asphalt, concrete, or boards, obstacles shall be permitted to not exceed 1 inch (25 mm) in height measured vertically to the highest point....
-
1014.2.1 Transfer Access
The surface of the clear ground space is required to be firm and stable, and to slope not steeper than 1:48 in any direction....
-
1.1.16 Alternate measurement tools
Measure running slope along the same lines of measurements as stated in Section 1.1.13 Although the F - number system can be used to measure surface flatness for smooth surfaces it requires...
-
M102.1 Defined Terms
The following terms are defined in the proposed standards: Enforcing authority, medical diagnostic equipment, operable parts, and transfer surface....
-
Section 35.151(i) Curb ramps (Section-by-Section Analysis)
Upon further consideration, however, the Department has concluded that the regulation should acknowledge that there are times when there are transitions from sidewalk to road surface that...
-
11B-1002.5 Amusement ride seats designed for transfer
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
